On 05/10/2012 07:55 PM, Thomas Abraham wrote: > On 2 May 2012 13:19, Jaehoon Chung <jh80.chung@xxxxxxxxxxx> wrote: >> On 05/02/2012 04:01 PM, Kyungmin Park wrote: >> >>> Hi, >>> >>> On 5/2/12, Thomas Abraham <thomas.abraham@xxxxxxxxxx> wrote: >>>> The instantiation of the Synopsis Designware controller on Exynos5250 >>>> include extension for SDR and DDR specific tx/rx phase shift timing >>>> and CIU internal divider. In addition to that, the option to skip the >>>> command hold stage is also introduced. Add support for these Exynos5250 >>>> specfic extenstions. > > [...] > >>>> @@ -265,6 +266,10 @@ static u32 dw_mci_prepare_command(struct mmc_host *mmc, >>>> struct mmc_command *cmd) >>>> cmdr |= SDMMC_CMD_DAT_WR; >>>> } >>>> >>>> + if (slot->host->drv_data->ctrl_type == DW_MCI_TYPE_EXYNOS5250) >>>> + if (SDMMC_CLKSEL_GET_SELCLK_DRV(mci_readl(slot->host, CLKSEL))) >>>> + cmdr |= SDMMC_USE_HOLD_REG; >>> Some other board, custom SOC also can use this HOLD register. So it's >>> not EXYNOS5250 specific one. I think we introduce the more generic >>> quirks for this instead of SOC specific. >> >> One more, I think that also need to check the IMPLEMENT_HOLD_REG bit in HCON register. >> It has dependency with that. > > The above code is specific to Exynos5250 and hence it is not required > to check the IMPLEMENT_HOLD_REG bit in HCON register. On Exynos5250, > the hold register is implemented and available. Right, the above code is specific for Exynos5250. But HOLD_REG should be used in other SoC. it's not only Exynos5250 specific. I want more generic code than specific code for Exynos5250. Best Regards, Jaehoon Chung > > >> As Mr.Park is mentioned, this register is clock phasing. >> In spec, card is enumerated in SDR12 or SDR25 mode, the application must program the use_hold_reg. > > Exynos5250 hardware manual specifies additional restrictions on the > use of hold register. The above code checks for those restrictions and > programs the USE_HOLD_REG accordingly. Please let me know if there is > any condition that is not handled by the above code. > > Thanks, > Thomas. > >> >> Best Regards, >> Jaehoon Chung >> > -- > To unsubscribe from this list: send the line "unsubscribe linux-mmc" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |