On 7 September 2011 07:19, Kyungmin Park <kmpark@xxxxxxxxxxxxx> wrote:
> On Tue, Sep 6, 2011 at 7:59 PM, Girish K S
> <girish.shivananjappa@xxxxxxxxxx> wrote:
>> This patch adds the power off notification handling
>> during suspend and system poweroff.
>> For suspend mode short timeout is used, whereas for the
>> normal poweroff long timeout is used.
>>
>> Signed-off-by: Girish K S <girish.shivananjappa@xxxxxxxxxx>
>> ---
>> drivers/mmc/core/core.c | 33 +++++++++++++++++++++++++++++++++
>> drivers/mmc/core/mmc.c | 4 +++-
>> drivers/mmc/host/sdhci.c | 10 ++++++++++
>> include/linux/mmc/card.h | 19 +++++++++++++++++++
>> include/linux/mmc/host.h | 4 ++++
>> 5 files changed, 69 insertions(+), 1 deletions(-)
>>
>> diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
>> index a65e1ca..16da927 100644
>> --- a/drivers/mmc/core/core.c
>> +++ b/drivers/mmc/core/core.c
>> @@ -1130,9 +1130,38 @@ static void mmc_power_up(struct mmc_host *host)
>>
>> static void mmc_power_off(struct mmc_host *host)
>> {
>> + struct mmc_card *card = host->card;
>> + unsigned int notify_type;
>> + unsigned int timeout;
>> + int err;
>> +
>> host->ios.clock = 0;
>> host->ios.vdd = 0;
>>
>> + if (mmc_card_mmc(card) &&
>> + (mmc_card_powernotify_on(card))) {
>> +
>> + if (host->power_notify_type == MMC_HOST_PW_NOTIFY_SHORT) {
>> + notify_type = EXT_CSD_POWER_OFF_SHORT;
>> + timeout = card->ext_csd.generic_cmd6_time;
>> + mmc_card_set_powernotify_short(card);
>> + } else {
>> + notify_type = EXT_CSD_POWER_OFF_LONG;
>> + timeout = card->ext_csd.power_off_longtime;
>> + mmc_card_set_powernotify_long(card);
>> + }
>> +
>> + err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
>> + EXT_CSD_POWER_OFF_NOTIFICATION,
>> + notify_type, timeout);
>> +
>> + if (err && err != -EBADMSG)
>> + printk(KERN_ERR "Device failed to respond "
>> + "within %d poweroff time."
>> + "forcefully powering down"
>> + "the device\n", timeout);
>> + }
>> +
> Okay this function is called when suspend.
>> /*
>> * Reset ocr mask to be the highest possible voltage supported for
>> * this mmc host. This value will be used at next power up.
>> @@ -1147,6 +1176,8 @@ static void mmc_power_off(struct mmc_host *host)
>> host->ios.bus_width = MMC_BUS_WIDTH_1;
>> host->ios.timing = MMC_TIMING_LEGACY;
>> mmc_set_ios(host);
>> + /*Set the card state to no notification after the poweroff*/
>> + mmc_card_set_powernotify_off(card);
>> }
>>
>> /*
>> @@ -2026,6 +2057,7 @@ int mmc_pm_notify(struct notifier_block *notify_block,
>>
>> spin_lock_irqsave(&host->lock, flags);
>> host->rescan_disable = 1;
>> + host->power_notify_type = MMC_HOST_PW_NOTIFY_SHORT;
>> spin_unlock_irqrestore(&host->lock, flags);
>> cancel_delayed_work_sync(&host->detect);
>>
>> @@ -2048,6 +2080,7 @@ int mmc_pm_notify(struct notifier_block *notify_block,
>>
>> spin_lock_irqsave(&host->lock, flags);
>> host->rescan_disable = 0;
>> + host->power_notify_type = MMC_HOST_PW_NOTIFY_LONG;
>> spin_unlock_irqrestore(&host->lock, flags);
>> mmc_detect_change(host, 0);
>>
>> diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
>> index 2f06b37..8868da8 100644
>> --- a/drivers/mmc/core/mmc.c
>> +++ b/drivers/mmc/core/mmc.c
>> @@ -715,13 +715,15 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
>> * If the host supports the power_off_notify capability then
>> * set the notification byte in the ext_csd register of device
>> */
>> - if (host->caps & MMC_CAP_POWER_OFF_NOTIFY) {
>> + if ((host->caps & MMC_CAP_POWER_OFF_NOTIFY) &&
>> + (mmc_card_powernotify_off(card))) {
>> err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
>> EXT_CSD_POWER_OFF_NOTIFICATION,
>> EXT_CSD_POWER_ON,
>> card->ext_csd.generic_cmd6_time);
>> if (err && err != -EBADMSG)
>> goto free_card;
>> + mmc_card_set_powernotify_on(card);
>> }
>>
>> /*
>> diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
>> index 0e02cc1..2ca427a 100644
>> --- a/drivers/mmc/host/sdhci.c
>> +++ b/drivers/mmc/host/sdhci.c
>> @@ -2566,6 +2566,16 @@ int sdhci_add_host(struct sdhci_host *host)
>> if (caps[1] & SDHCI_DRIVER_TYPE_D)
>> mmc->caps |= MMC_CAP_DRIVER_TYPE_D;
>>
>> + /*
>> + * If Notify capability is enabled and
>> + * notify type is not initialised by host, set default to
>> + * long power off notify timeout value
>> + */
>> + if (mmc->caps == MMC_CAP_POWER_OFF_NOTIFY)
> You should be check the mmc->caps & MMC_CAP_*. I think it's almost false.
oops.. will change it.
>> + mmc->power_notify_type = MMC_HOST_PW_NOTIFY_SHORT;
>> + else
>> + mmc->power_notify_type = MMC_HOST_PW_NOTIFY_NONE;
>> +
>> /* Initial value for re-tuning timer count */
>> host->tuning_count = (caps[1] & SDHCI_RETUNING_TIMER_COUNT_MASK) >>
>> SDHCI_RETUNING_TIMER_COUNT_SHIFT;
>> diff --git a/include/linux/mmc/card.h b/include/linux/mmc/card.h
>> index 2bf2843..1d6a832 100644
>> --- a/include/linux/mmc/card.h
>> +++ b/include/linux/mmc/card.h
>> @@ -190,6 +190,11 @@ struct mmc_card {
>> #define MMC_QUIRK_DISABLE_CD (1<<5) /* disconnect CD/DAT[3] resistor */
>> #define MMC_QUIRK_INAND_CMD38 (1<<6) /* iNAND devices have broken CMD38 */
>> #define MMC_QUIRK_BLK_NO_CMD23 (1<<7) /* Avoid CMD23 for regular multiblock */
>> + unsigned int poweroff_notify_state;/*eMMC4.5 notify feature */
>> +#define MMC_NO_POWER_NOTIFICATION 0
>> +#define MMC_POWERED_ON 1
>> +#define MMC_POWEROFF_SHORT 2
>> +#define MMC_POWEROFF_LONG 3
>>
>> unsigned int erase_size; /* erase size in sectors */
>> unsigned int erase_shift; /* if erase unit is power 2 */
>> @@ -325,6 +330,20 @@ static inline void __maybe_unused remove_quirk(struct mmc_card *card, int data)
>> #define mmc_sd_card_set_uhs(c) ((c)->state |= MMC_STATE_ULTRAHIGHSPEED)
>> #define mmc_card_set_ext_capacity(c) ((c)->state |= MMC_CARD_SDXC)
>>
>> +#define mmc_card_powernotify_on(c) \
>> + ((c)->poweroff_notify_state == MMC_POWERED_ON)
>> +#define mmc_card_powernotify_off(c) \
>> + ((c)->poweroff_notify_state == MMC_NO_POWER_NOTIFICATION)
>> +
>> +#define mmc_card_set_powernotify_off(c) \
>> + ((c)->poweroff_notify_state = MMC_NO_POWER_NOTIFICATION)
>> +#define mmc_card_set_powernotify_on(c) \
>> + ((c)->poweroff_notify_state = MMC_POWERED_ON)
>> +#define mmc_card_set_powernotify_short(c) \
>> + ((c)->poweroff_notify_state = MMC_POWEROFF_SHORT)
>> +#define mmc_card_set_powernotify_long(c) \
>> + ((c)->poweroff_notify_state = MMC_POWEROFF_LONG)
>> +
>> /*
>> * Quirk add/remove for MMC products.
>> */
>> diff --git a/include/linux/mmc/host.h b/include/linux/mmc/host.h
>> index cf2dadc..4f24702 100644
>> --- a/include/linux/mmc/host.h
>> +++ b/include/linux/mmc/host.h
>> @@ -232,6 +232,10 @@ struct mmc_host {
>> #define MMC_CAP_POWER_OFF_NOTIFY (1 << 31)/*Notify poweroff supported */
>>
>> mmc_pm_flag_t pm_caps; /* supported pm features */
>> + unsigned int power_notify_type;
>> +#define MMC_HOST_PW_NOTIFY_NONE 0
>> +#define MMC_HOST_PW_NOTIFY_SHORT 1
>> +#define MMC_HOST_PW_NOTIFY_LONG 2
>
>> +#define MMC_NO_POWER_NOTIFICATION 0
>> +#define MMC_POWERED_ON 1
>> +#define MMC_POWEROFF_SHORT 2
>> +#define MMC_POWEROFF_LONG 3
>
> I think you can make one macros.
but these macros are in 2 different contexts card and host.
if i make it a single macro pls suggest me a better place to define.
should it be host.h or card.h?
>
>>
>> #ifdef CONFIG_MMC_CLKGATE
>> int clk_requests; /* internal reference counter */
>> --
>> 1.7.1
>>
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
>> the body of a message to majordomo@xxxxxxxxxxxxxxx
>> More majordomo info at http://vger.kernel.org/majordomo-info.html
>>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
