When we test something, i.e. do a report() we want unique messages,
otherwise, from the test output, it will appear as if the same test was
run multiple times, possible with different PASS/FAIL values.
Convert some reports that don't actually test anything topology specific
into asserts.
Refine the report message for others.
Reviewed-by: Janosch Frank <frankja@xxxxxxxxxxxxx>
Reviewed-by: Nico Boehr <nrb@xxxxxxxxxxxxx>
Signed-off-by: Nina Schoetterl-Glausch <nsg@xxxxxxxxxxxxx>
---
s390x/topology.c | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/s390x/topology.c b/s390x/topology.c
index c8ad4bcb..03bc3d3b 100644
--- a/s390x/topology.c
+++ b/s390x/topology.c
@@ -114,7 +114,7 @@ static void check_polarization_change(void)
report_prefix_push("Polarization change");
/* We expect a clean state through reset */
- report(diag308_load_reset(1), "load normal reset done");
+ assert(diag308_load_reset(1));
/*
* Set vertical polarization to verify that RESET sets
@@ -123,7 +123,7 @@ static void check_polarization_change(void)
cc = ptf(PTF_REQ_VERTICAL, &rc);
report(cc == 0, "Set vertical polarization.");
- report(diag308_load_reset(1), "load normal reset done");
+ assert(diag308_load_reset(1));
cc = ptf(PTF_CHECK, &rc);
report(cc == 0, "Reset should clear topology report");
@@ -137,25 +137,25 @@ static void check_polarization_change(void)
report(cc == 0, "Change to vertical");
cc = ptf(PTF_CHECK, &rc);
- report(cc == 1, "Should report");
+ report(cc == 1, "Should report change after horizontal -> vertical");
cc = ptf(PTF_REQ_VERTICAL, &rc);
report(cc == 2 && rc == PTF_ERR_ALRDY_POLARIZED, "Double change to vertical");
cc = ptf(PTF_CHECK, &rc);
- report(cc == 0, "Should not report");
+ report(cc == 0, "Should not report change after vertical -> vertical");
cc = ptf(PTF_REQ_HORIZONTAL, &rc);
report(cc == 0, "Change to horizontal");
cc = ptf(PTF_CHECK, &rc);
- report(cc == 1, "Should Report");
+ report(cc == 1, "Should report change after vertical -> horizontal");
cc = ptf(PTF_REQ_HORIZONTAL, &rc);
report(cc == 2 && rc == PTF_ERR_ALRDY_POLARIZED, "Double change to horizontal");
cc = ptf(PTF_CHECK, &rc);
- report(cc == 0, "Should not report");
+ report(cc == 0, "Should not report change after horizontal -> horizontal");
report_prefix_pop();
}
--
2.41.0
