From: Ilya Leoshkevich <iii@xxxxxxxxxxxxx>
Currently, after single-stepping an instruction that generates a
specification exception, GDB ends up on the instruction immediately
following it.
The reason is that vcpu_post_run() injects the interrupt and sets
KVM_GUESTDBG_EXIT_PENDING, causing a KVM_SINGLESTEP exit. The
interrupt is not delivered, however, therefore userspace sees the
address of the next instruction.
Fix by letting the __vcpu_run() loop go into the next iteration,
where vcpu_pre_run() delivers the interrupt and sets
KVM_GUESTDBG_EXIT_PENDING.
Reviewed-by: David Hildenbrand <david@xxxxxxxxxx>
Signed-off-by: Ilya Leoshkevich <iii@xxxxxxxxxxxxx>
Reviewed-by: Claudio Imbrenda <imbrenda@xxxxxxxxxxxxx>
Message-ID: <20230725143857.228626-3-iii@xxxxxxxxxxxxx>
Signed-off-by: Claudio Imbrenda <imbrenda@xxxxxxxxxxxxx>
Signed-off-by: Janosch Frank <frankja@xxxxxxxxxxxxx>
---
arch/s390/kvm/intercept.c | 17 ++++++++++++++++-
1 file changed, 16 insertions(+), 1 deletion(-)
diff --git a/arch/s390/kvm/intercept.c b/arch/s390/kvm/intercept.c
index 954d39adf85c..e54496740859 100644
--- a/arch/s390/kvm/intercept.c
+++ b/arch/s390/kvm/intercept.c
@@ -228,6 +228,21 @@ static int handle_itdb(struct kvm_vcpu *vcpu)
#define per_event(vcpu) (vcpu->arch.sie_block->iprcc & PGM_PER)
+static bool should_handle_per_event(const struct kvm_vcpu *vcpu)
+{
+ if (!guestdbg_enabled(vcpu) || !per_event(vcpu))
+ return false;
+ if (guestdbg_sstep_enabled(vcpu) &&
+ vcpu->arch.sie_block->iprcc != PGM_PER) {
+ /*
+ * __vcpu_run() will exit after delivering the concurrently
+ * indicated condition.
+ */
+ return false;
+ }
+ return true;
+}
+
static int handle_prog(struct kvm_vcpu *vcpu)
{
psw_t psw;
@@ -242,7 +257,7 @@ static int handle_prog(struct kvm_vcpu *vcpu)
if (kvm_s390_pv_cpu_is_protected(vcpu))
return -EOPNOTSUPP;
- if (guestdbg_enabled(vcpu) && per_event(vcpu)) {
+ if (should_handle_per_event(vcpu)) {
rc = kvm_s390_handle_per_event(vcpu);
if (rc)
return rc;
--
2.41.0
