Use the general page fault accounting by passing regs into handle_mm_fault().
It naturally solve the issue of multiple page fault accounting when page fault
retry happened.
CC: Heiko Carstens <heiko.carstens@xxxxxxxxxx>
CC: Vasily Gorbik <gor@xxxxxxxxxxxxx>
CC: Christian Borntraeger <borntraeger@xxxxxxxxxx>
CC: linux-s390@xxxxxxxxxxxxxxx
Reviewed-by: Gerald Schaefer <gerald.schaefer@xxxxxxxxxx>
Acked-by: Gerald Schaefer <gerald.schaefer@xxxxxxxxxx>
Signed-off-by: Peter Xu <peterx@xxxxxxxxxx>
---
arch/s390/mm/fault.c | 16 +---------------
1 file changed, 1 insertion(+), 15 deletions(-)
diff --git a/arch/s390/mm/fault.c b/arch/s390/mm/fault.c
index fc14df0b4d6e..9aa201df2e94 100644
--- a/arch/s390/mm/fault.c
+++ b/arch/s390/mm/fault.c
@@ -478,7 +478,7 @@ static inline vm_fault_t do_exception(struct pt_regs *regs, int access)
* make sure we exit gracefully rather than endlessly redo
* the fault.
*/
- fault = handle_mm_fault(vma, address, flags, NULL);
+ fault = handle_mm_fault(vma, address, flags, regs);
if (fault_signal_pending(fault, regs)) {
fault = VM_FAULT_SIGNAL;
if (flags & FAULT_FLAG_RETRY_NOWAIT)
@@ -488,21 +488,7 @@ static inline vm_fault_t do_exception(struct pt_regs *regs, int access)
if (unlikely(fault & VM_FAULT_ERROR))
goto out_up;
- /*
- * Major/minor page fault accounting is only done on the
- * initial attempt. If we go through a retry, it is extremely
- * likely that the page will be found in page cache at that point.
- */
if (flags & FAULT_FLAG_ALLOW_RETRY) {
- if (fault & VM_FAULT_MAJOR) {
- tsk->maj_flt++;
- perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MAJ, 1,
- regs, address);
- } else {
- tsk->min_flt++;
- perf_sw_event(PERF_COUNT_SW_PAGE_FAULTS_MIN, 1,
- regs, address);
- }
if (fault & VM_FAULT_RETRY) {
if (IS_ENABLED(CONFIG_PGSTE) && gmap &&
(flags & FAULT_FLAG_RETRY_NOWAIT)) {
--
2.26.2
