When an OSA device in prio-queue setup is reduced to 1 TX queue due to
HW restrictions, we reset its the default_out_queue to 0.
In the old code this was needed so that qeth_get_priority_queue() gets
the queue selection right. But with proper multiqueue support we already
reduced dev->real_num_tx_queues to 1, and so the stack puts all traffic
on txq 0 without even calling .ndo_select_queue.
Thus we can preserve the user's configuration, and apply it if the OSA
device later re-gains support for multiple TX queues.
Fixes: 73dc2daf110f ("s390/qeth: add TX multiqueue support for OSA devices")
Signed-off-by: Julian Wiedmann <jwi@xxxxxxxxxxxxx>
---
drivers/s390/net/qeth_core_main.c | 1 -
1 file changed, 1 deletion(-)
diff --git a/drivers/s390/net/qeth_core_main.c b/drivers/s390/net/qeth_core_main.c
index 8ca85c8a01a1..2a05d13a0e79 100644
--- a/drivers/s390/net/qeth_core_main.c
+++ b/drivers/s390/net/qeth_core_main.c
@@ -1204,7 +1204,6 @@ static int qeth_osa_set_output_queues(struct qeth_card *card, bool single)
if (count == 1)
dev_info(&card->gdev->dev, "Priority Queueing not supported\n");
- card->qdio.default_out_queue = single ? 0 : QETH_DEFAULT_QUEUE;
card->qdio.no_out_queues = count;
return 0;
}
--
2.17.1
