A card's close_dev work is scheduled on a driver-wide workqueue. If the card is removed and freed while the work is still active, this causes a use-after-free. So make sure that the work is completed before freeing the card. Fixes: 0f54761d167f ("qeth: Support VEPA mode") Signed-off-by: Julian Wiedmann <jwi@xxxxxxxxxxxxx> --- drivers/s390/net/qeth_core.h | 1 + drivers/s390/net/qeth_l2_main.c | 2 ++ drivers/s390/net/qeth_l3_main.c | 1 + 3 files changed, 4 insertions(+) diff --git a/drivers/s390/net/qeth_core.h b/drivers/s390/net/qeth_core.h index 0ee026947f20..1cf45ace0dd0 100644 --- a/drivers/s390/net/qeth_core.h +++ b/drivers/s390/net/qeth_core.h @@ -22,6 +22,7 @@ #include <linux/hashtable.h> #include <linux/ip.h> #include <linux/refcount.h> +#include <linux/workqueue.h> #include <net/ipv6.h> #include <net/if_inet6.h> diff --git a/drivers/s390/net/qeth_l2_main.c b/drivers/s390/net/qeth_l2_main.c index f108d4b44605..9fec0117fc00 100644 --- a/drivers/s390/net/qeth_l2_main.c +++ b/drivers/s390/net/qeth_l2_main.c @@ -801,6 +801,8 @@ static void qeth_l2_remove_device(struct ccwgroup_device *cgdev) if (cgdev->state == CCWGROUP_ONLINE) qeth_l2_set_offline(cgdev); + + cancel_work_sync(&card->close_dev_work); if (qeth_netdev_is_registered(card->dev)) unregister_netdev(card->dev); } diff --git a/drivers/s390/net/qeth_l3_main.c b/drivers/s390/net/qeth_l3_main.c index 42a7cdc59b76..5e810561cb12 100644 --- a/drivers/s390/net/qeth_l3_main.c +++ b/drivers/s390/net/qeth_l3_main.c @@ -2338,6 +2338,7 @@ static void qeth_l3_remove_device(struct ccwgroup_device *cgdev) if (cgdev->state == CCWGROUP_ONLINE) qeth_l3_set_offline(cgdev); + cancel_work_sync(&card->close_dev_work); if (qeth_netdev_is_registered(card->dev)) unregister_netdev(card->dev); qeth_l3_clear_ip_htable(card, 0); -- 2.16.4