Enable wakeup in the hym8563 driver if the IRQ was successfully
requested or if wakeup-source is set in the devicetree.
As per the description of device_init_wakeup(), it should be enabled
for "devices that everyone expects to be wakeup sources". One would
expect this to be the case with a real-time clock.
Tested on rk3288-rock2-square, which has an IRQ configured for the
RTC. As a result, wakeup was enabled during driver initialisation.
Fixes: dcaf03849352 ("rtc: add hym8563 rtc-driver")
Reported-by: kernelci.org bot <bot@xxxxxxxxxxxx>
Signed-off-by: Guillaume Tucker <guillaume.tucker@xxxxxxxxxxxxx>
---
Notes:
v2: enable wakeup if irq or wakeup-source
drivers/rtc/rtc-hym8563.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/rtc/rtc-hym8563.c b/drivers/rtc/rtc-hym8563.c
index 0fb79c4afb46..24e0095be058 100644
--- a/drivers/rtc/rtc-hym8563.c
+++ b/drivers/rtc/rtc-hym8563.c
@@ -527,8 +527,6 @@ static int hym8563_probe(struct i2c_client *client,
hym8563->client = client;
i2c_set_clientdata(client, hym8563);
- device_set_wakeup_capable(&client->dev, true);
-
ret = hym8563_init_device(client);
if (ret) {
dev_err(&client->dev, "could not init device, %d\n", ret);
@@ -547,6 +545,11 @@ static int hym8563_probe(struct i2c_client *client,
}
}
+ if (client->irq > 0 ||
+ device_property_read_bool(&client->dev, "wakeup-source")) {
+ device_init_wakeup(&client->dev, true);
+ }
+
/* check state of calendar information */
ret = i2c_smbus_read_byte_data(client, HYM8563_SEC);
if (ret < 0)
--
2.20.1
