Cut down the shutdown time from 2 seconds to 1 sec. In case of roll
over try again.
Signed-off-by: Keerthy <j-keerthy@xxxxxx>
---
drivers/rtc/rtc-omap.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/drivers/rtc/rtc-omap.c b/drivers/rtc/rtc-omap.c
index 323ff55..14f2241 100644
--- a/drivers/rtc/rtc-omap.c
+++ b/drivers/rtc/rtc-omap.c
@@ -441,11 +441,12 @@ static void omap_rtc_power_off(void)
val = rtc_readl(rtc, OMAP_RTC_PMIC_REG);
rtc_writel(rtc, OMAP_RTC_PMIC_REG, val | OMAP_RTC_PMIC_POWER_EN_EN);
- /* set alarm two seconds from now */
+again:
+ /* set alarm one second from now */
omap_rtc_read_time_raw(rtc, &tm);
bcd2tm(&tm);
rtc_tm_to_time(&tm, &now);
- rtc_time_to_tm(now + 2, &tm);
+ rtc_time_to_tm(now + 1, &tm);
if (tm2bcd(&tm) < 0) {
dev_err(&rtc->rtc->dev, "power off failed\n");
@@ -455,6 +456,10 @@ static void omap_rtc_power_off(void)
rtc_wait_not_busy(rtc);
+ /* Our calculations started right before the rollover, try again */
+ if (seconds != rtc_read(omap_rtc_power_off_rtc, OMAP_RTC_SECONDS_REG))
+ goto again;
+
rtc_write(rtc, OMAP_RTC_ALARM2_SECONDS_REG, tm.tm_sec);
rtc_write(rtc, OMAP_RTC_ALARM2_MINUTES_REG, tm.tm_min);
rtc_write(rtc, OMAP_RTC_ALARM2_HOURS_REG, tm.tm_hour);
--
1.9.1
