To enable the domain-idle-states to be used during s2idle on a PREEMPT_RT
based configuration, let's allow the re-assignment of the ->enter_s2idle()
callback to psci_enter_s2idle_domain_idle_state().
Similar to s2ram, let's leave the support for CPU hotplug outside
PREEMPT_RT, as it's depending on using runtime PM. For s2idle, this means
that an offline CPU's PM domain will remain powered-on. In practise this
may lead to that a shallower idle-state than necessary gets selected, which
shouldn't be an issue (besides wasting power).
Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx>
---
drivers/cpuidle/cpuidle-psci.c | 13 ++++++-------
1 file changed, 6 insertions(+), 7 deletions(-)
diff --git a/drivers/cpuidle/cpuidle-psci.c b/drivers/cpuidle/cpuidle-psci.c
index ad6ce9fe12b4..2562dc001fc1 100644
--- a/drivers/cpuidle/cpuidle-psci.c
+++ b/drivers/cpuidle/cpuidle-psci.c
@@ -233,18 +233,17 @@ static int psci_dt_cpu_init_topology(struct cpuidle_driver *drv,
psci_cpuidle_use_syscore = true;
- /* The hierarchical topology is limited to s2ram on PREEMPT_RT. */
- if (IS_ENABLED(CONFIG_PREEMPT_RT))
- return 0;
-
/*
* Using the deepest state for the CPU to trigger a potential selection
* of a shared state for the domain, assumes the domain states are all
- * deeper states.
+ * deeper states. On PREEMPT_RT the hierarchical topology is limited to
+ * s2ram and s2idle.
*/
- drv->states[state_count - 1].enter = psci_enter_domain_idle_state;
drv->states[state_count - 1].enter_s2idle = psci_enter_s2idle_domain_idle_state;
- psci_cpuidle_use_cpuhp = true;
+ if (!IS_ENABLED(CONFIG_PREEMPT_RT)) {
+ drv->states[state_count - 1].enter = psci_enter_domain_idle_state;
+ psci_cpuidle_use_cpuhp = true;
+ }
return 0;
}
--
2.34.1
