在 2020/5/21 18:51, Anand Moon 写道:
Hi Shawn,
On Thu, 21 May 2020 at 06:35, Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> wrote:
According to RK3399 user manual, bit 9 in PCIE_RC_BAR_CONF should
be set, otherwise accessing to IO base and limit registers would
fail.
[ 0.411318] pci_bus 0000:00: root bus resource [bus 00-1f]
[ 0.411822] pci_bus 0000:00: root bus resource [mem 0xfa000000-0xfbdfffff]
[ 0.412440] pci_bus 0000:00: root bus resource [io 0x0000-0xfffff] (bus address [0xfbe00000-0xfbefffff])
[ 0.413665] pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring
[ 0.414698] pci 0000:01:00.0: reg 0x10: initial BAR value 0x00000000 invalid
[ 0.415412] pci 0000:01:00.0: reg 0x18: initial BAR value 0x00000000 invalid
[ 0.418456] pci 0000:00:00.0: BAR 8: assigned [mem 0xfa000000-0xfa0fffff]
[ 0.419065] pci 0000:01:00.0: BAR 1: assigned [mem 0xfa000000-0xfa007fff pref]
[ 0.419728] pci 0000:01:00.0: BAR 6: assigned [mem 0xfa008000-0xfa00ffff pref]
[ 0.420377] pci 0000:01:00.0: BAR 0: no space for [io size 0x0100]
[ 0.420935] pci 0000:01:00.0: BAR 0: failed to assign [io size 0x0100]
[ 0.421526] pci 0000:01:00.0: BAR 2: no space for [io size 0x0004]
[ 0.422084] pci 0000:01:00.0: BAR 2: failed to assign [io size 0x0004]
[ 0.422687] pci 0000:00:00.0: PCI bridge to [bus 01]
[ 0.423135] pci 0000:00:00.0: bridge window [mem 0xfa000000-0xfa0fffff]
[ 0.423794] pcieport 0000:00:00.0: enabling device (0000 -> 0002)
[ 0.424566] pcieport 0000:00:00.0: Signaling PME through PCIe PME interrupt
[ 0.425182] pci 0000:01:00.0: Signaling PME through PCIe PME interrupt
01:00.0 Class 0700: Device 1c00:3853 (rev 10) (prog-if 05)
Subsystem: Device 1c00:3853
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 230
Region 0: I/O ports at <unassigned> [disabled]
Region 1: Memory at fa000000 (32-bit, prefetchable) [disabled] [size=32K]
Region 2: I/O ports at <unassigned> [disabled]
[virtual] Expansion ROM at fa008000 [disabled] [size=32K]
Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
---
I have old development board Odroid N1 (RK3399), It has onboard PCIe
2 dual sata bridge.
I have tested this patch, but I am still getting following log on
Odroid N1 board.
Is their any more configuration needed for sata ports ?
Thanks for testing. I made a mistake that it should be bit 19, so
can you try using BIT(19)?
[ 7.444504] pci_bus 0000:01: busn_res: [bus 01-1f] end is updated to 01
[ 7.445521] panfrost ff9a0000.gpu: Features: L2:0x07120206
Shader:0x00000000 Tiler:0x00000809 Mem:0x1 MMU:0x00002830 AS:0xff
JS:0x7
[ 7.452246] pci 0000:00:00.0: BAR 14: assigned [mem 0xfa000000-0xfa0fffff]
[ 7.460106] panfrost ff9a0000.gpu: shader_present=0xf l2_present=0x1
[ 7.466459] pci 0000:01:00.0: BAR 6: assigned [mem
0xfa000000-0xfa00ffff pref]
[ 7.473679] panfrost ff9a0000.gpu: [drm:panfrost_devfreq_init
[panfrost]] Failed to register cooling device
[ 7.479703] pci 0000:01:00.0: BAR 5: assigned [mem 0xfa010000-0xfa0101ff]
[ 7.487706] [drm] Initialized panfrost 1.1.0 20180908 for
ff9a0000.gpu on minor 0
[ 7.494343] pci 0000:01:00.0: BAR 4: no space for [io size 0x0010]
[ 7.494348] pci 0000:01:00.0: BAR 4: failed to assign [io size 0x0010]
[ 7.494352] pci 0000:01:00.0: BAR 0: no space for [io size 0x0008]
[ 7.494356] pci 0000:01:00.0: BAR 0: failed to assign [io size 0x0008]
[ 7.494360] pci 0000:01:00.0: BAR 2: no space for [io size 0x0008]
[ 7.494364] pci 0000:01:00.0: BAR 2: failed to assign [io size 0x0008]
[ 7.494368] pci 0000:01:00.0: BAR 1: no space for [io size 0x0004]
[ 7.494372] pci 0000:01:00.0: BAR 1: failed to assign [io size 0x0004]
[ 7.578910] rockchip-vop ff8f0000.vop: Adding to iommu group 3
[ 7.587074] pci 0000:01:00.0: BAR 3: no space for [io size 0x0004]
[ 7.594780] rockchip-vop ff900000.vop: Adding to iommu group 4
[ 7.607701] pci 0000:01:00.0: BAR 3: failed to assign [io size 0x0004]
# lspci -v
00:00.0 PCI bridge: Fuzhou Rockchip Electronics Co., Ltd RK3399 PCI
Express Root Port (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0, IRQ 237
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 00000000-00000fff [size=4K]
Memory behind bridge: fa000000-fa0fffff [size=1M]
Prefetchable memory behind bridge: 00000000-000fffff [size=1M]
Capabilities: [80] Power Management version 3
Capabilities: [90] MSI: Enable+ Count=1/1 Maskable+ 64bit+
Capabilities: [b0] MSI-X: Enable- Count=1 Masked-
Capabilities: [c0] Express Root Port (Slot+), MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [274] Transaction Processing Hints
Kernel driver in use: pcieport
01:00.0 IDE interface: ASMedia Technology Inc. ASM1061 SATA IDE
Controller (rev 02) (prog-if 85 [PCI native mode-only controller,
supports bus mastering])
Subsystem: ASMedia Technology Inc. ASM1061 SATA IDE Controller
Flags: bus master, fast devsel, latency 0, IRQ 238
I/O ports at <unassigned> [disabled]
I/O ports at <unassigned> [disabled]
I/O ports at <unassigned> [disabled]
I/O ports at <unassigned> [disabled]
I/O ports at <unassigned> [disabled]
Memory at fa010000 (32-bit, non-prefetchable) [size=512]
Expansion ROM at fa000000 [virtual] [disabled] [size=64K]
Capabilities: [50] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [78] Power Management version 3
Capabilities: [80] Express Legacy Endpoint, MSI 00
Capabilities: [100] Virtual Channel
Kernel driver in use: ahci
Best Regards
-Anand
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
