On the Pinebook Pro the headphone jack is dual use. It can be used either
as a normal headphone jack or as a debug serial connection. This
functionality is controlled via a small hardware switch on the mainboard.
Unfortunately flipping this switch biases the headphone detection switch
inside the headphone jack at 3.3 V if in `debug UART` position but
to GND when in `headphone out` position.
This results in an inversion of the headphone detection logic depending
on the switch position.
Since the headphone jack can only be used for audio when in
`headphone out` position this commit changes the headphone detect GPIO
logic to be correct for that case rather than for the debug UART.
Signed-off-by: Tobias Schramm <t.schramm@xxxxxxxxxxx>
---
arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts b/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
index 5ea281b55fe2..c3f15f5bd550 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
@@ -147,7 +147,7 @@ es8316-sound {
"Speaker", "Speaker Amplifier OUTL",
"Speaker", "Speaker Amplifier OUTR";
- simple-audio-card,hp-det-gpio = <&gpio0 RK_PB0 GPIO_ACTIVE_LOW>;
+ simple-audio-card,hp-det-gpio = <&gpio0 RK_PB0 GPIO_ACTIVE_HIGH>;
simple-audio-card,aux-devs = <&speaker_amp>;
simple-audio-card,pin-switches = "Speaker";
@@ -794,7 +794,7 @@ dc_det_gpio: dc-det-gpio {
es8316 {
hp_det_gpio: hp-det-gpio {
- rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_down>;
+ rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>;
};
};
--
2.26.0
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
