Hi,
Add more reg = <..>
On 3/3/20 4:37 PM, Johan Jonker wrote:
> Hi Tobias,
>
> Some minor style issues.
> This dts file contains a partition node.
> Question for the maintainers (Heiko?):
> Should that partition be included or not?
[..]
>> +&i2c4 {
>> + i2c-scl-falling-time-ns = <20>;
>> + i2c-scl-rising-time-ns = <600>;
>> + status = "okay";
>> +
>> + fusb0: fusb30x@22 {
>> + compatible = "fcs,fusb302";
>> + reg = <0x22>;
>> + fcs,int_n = <&gpio1 RK_PA2 GPIO_ACTIVE_HIGH>;
>> + pinctrl-names = "default";
>> + pinctrl-0 = <&fusb0_int_gpio>;
>
>> + status = "okay";
>
> Remove or else status below.
> New nodes are already okay I think.
> If insure check compiled flat dts output to see if it is still there.
>
>> + vbus-supply = <&vbus_typec>;
>> +
>> + connector {
>> + compatible = "usb-c-connector";
>> + label = "USB-C";
>> + op-sink-microwatt = <1000000>;
>> + power-role = "dual";
>> + sink-pdos =
>> + <PDO_FIXED(5000, 2500, PDO_FIXED_USB_COMM)>;
>> + source-pdos =
>> + <PDO_FIXED(5000, 1400, PDO_FIXED_USB_COMM)>;
>> + try-power-role = "sink";
>> +
>> + ports {
>> + #address-cells = <1>;
>> + #size-cells = <0>;
>> +
>> + port@0 {
reg = <0>;
>> + usbc_hs: endpoint {
>> + remote-endpoint =
>> + <&u2phy0_typec_hs>;
>> + };
>> + };
>> +
>> + port@1 {
reg = <1>;
>> + usbc_ss: endpoint {
>> + remote-endpoint =
>> + <&tcphy0_typec_ss>;
>> + };
>> + };
>> +
>> + port@2 {
reg = <2>;
>> + usbc_dp: endpoint {
>> + remote-endpoint =
>> + <&tcphy0_typec_dp>;
>> + };
>> + };
>> + };
>> + };
>> + };
>> +};
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
