On 2019/10/4 8:53, Soeren Moch wrote:
On 04.10.19 02:01, Robin Murphy wrote:
On 2019-10-03 10:50 pm, Soeren Moch wrote:
According to the RockPro64 schematic [1] the rk3399 sdmmc controller is
connected to a microSD (TF card) slot, which cannot be switched to 1.8V.
Really? AFAICS the SDMMC0 wiring looks pretty much identical to the
NanoPC-T4 schematic (it's the same reference design, after all), and I
know that board can happily drive a UHS-I microSD card with 1.8v I/Os,
because mine's doing so right now.
Robin.
OK, the RockPro64 does not allow a card reset (power cycle) since
VCC3V0_SD is directly connected to VCC3V3_SYS (via R89555), the
SDMMC0_PWH_H signal is not connected. So the card fails to identify
itself after suspend or reboot when switched to 1.8V operation.
I believe we addressed this issue long time ago, please check:
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/?id=6a11fc47f175c8d87018e89cb58e2d36c66534cb
Regards,
Soeren
So also configure the vcc_sdio regulator, which drives the i/o voltage
of the sdmmc controller, accordingly.
While at it, also remove the cap-mmc-highspeed property of the sdmmc
controller, since no mmc card can be connected here.
[1] http://files.pine64.org/doc/rockpro64/rockpro64_v21-SCH.pdf
Fixes: e4f3fb490967 ("arm64: dts: rockchip: add initial dts support
for Rockpro64")
Signed-off-by: Soeren Moch <smoch@xxxxxx>
---
Cc: Heiko Stuebner <heiko@xxxxxxxxx>
Cc: linux-rockchip@xxxxxxxxxxxxxxxxxxx
Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
---
arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
index 2e44dae4865a..084f1d994a50 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
@@ -353,7 +353,7 @@
regulator-name = "vcc_sdio";
regulator-always-on;
regulator-boot-on;
- regulator-min-microvolt = <1800000>;
+ regulator-min-microvolt = <3000000>;
regulator-max-microvolt = <3000000>;
regulator-state-mem {
regulator-on-in-suspend;
@@ -624,7 +624,6 @@
&sdmmc {
bus-width = <4>;
- cap-mmc-highspeed;
cap-sd-highspeed;
cd-gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
disable-wp;
--
2.17.1
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
--
Best Regards
Shawn Lin
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
