On Tue, May 07, 2019 at 01:22:03PM +0200, Heiko Stuebner wrote:
> Am Montag, 6. Mai 2019, 14:04:58 CEST schrieb Manivannan Sadhasivam:
> > Enable SPI1 exposed on both Low and High speed expansion connectors
> > of Ficus. SPI1 has 3 different chip selects wired as below:
> >
> > CS0 - Serial Flash (unpopulated)
> > CS1 - Low Speed expansion
> > CS2 - High Speed expansion
> >
> > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> > ---
> > arch/arm64/boot/dts/rockchip/rk3399-ficus.dts | 6 ++++++
> > 1 file changed, 6 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts b/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> > index 027d428917b8..9baa378fc770 100644
> > --- a/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> > +++ b/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> > @@ -146,6 +146,12 @@
> > };
> > };
> >
> > +&spi1 {
> > + /* On both Low speed and High speed expansion */
> > + cs-gpios = <0>, <&gpio4 6 0>, <&gpio4 7 0>;
>
> cs0 should still be part of the cs-gpios though (gpio1 RK_PB2).
> The flash is part of the schematics, so there might be board with
> it pre-populated or people might put a flash chip on it.
>
Why? CS0 is owned by the SPI controller itself, so we can't use it as
a GPIO. Otherwise, we need to change the pinctrl definition of it, which
doesn't look good to me.
> Also please use the constants for pin specification (RK_PA6, RK_PA7 above)
>
Sure.
Thanks,
Mani
>
> Heiko
>
> > + status = "okay";
> > +};
> > +
> > &usbdrd_dwc3_0 {
> > dr_mode = "host";
> > };
> >
>
>
>
>
_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-rockchip
