Am Samstag, 9. März 2019, 16:39:21 CET schrieb David Summers: > The Problem: > > On ASUS Tinker Board S, when booting from the eMMC, and there is card > in the sd slot, there are constant errors. > > Also when warm reboot, uboot can not access the sd slot > > Cause: > > Identified by Robin Murphy @ ARM. The Card Detect on rk3288 > devices is pulled up by vccio-sd; so when the regulator powers this > off, card detect gives spurious errors. A second problem, is during > power down, vccio-sd apprears to be powered down. This causes a > problem when warm rebooting from the sd card. This was identified by > Jonas Karlman. > > History: > > A common fault on these rk3288 board, which impliment the reference > design. > > When this arose before: > > http://lists.infradead.org/pipermail/linux-arm-kernel/2014-August/281153.html > > And Ulf and Jaehoon clearly said this was a broken card detect design, > which should be solved via polling > > Solution: > > Hence broken-cd is set as a property. This cures the errors. The > powering down of vccio-sd during reboot is cured by adding > regulator-boot-on. > > This solutions has been fairly widely reviewed and tested. > > Signed-off-by: David Summers <beagleboard@xxxxxxxxxxxxxxxxxxx> > Reviewed by: Robin Murphy <robin.murphy@xxxxxxx> > Reviewed by: Jonas Karlman <jonas@xxxxxxxxx> > Test by: TheSaint @ ArchLinux Arm please follow patch submission guidelines, here it would be Tested-by: ... with an actual Name + mail address Also I did try to go through the way big mail thread but didn't find an actual "Reviewed-by" from Robin Murphy, similar to what he pointed out in patch2 Other than that and including the past discussions, this looks good. Heiko > --- > arch/arm/boot/dts/rk3288-tinker.dtsi | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/arch/arm/boot/dts/rk3288-tinker.dtsi b/arch/arm/boot/dts/rk3288-tinker.dtsi > index aa107ee41b8b..ef653c3209bc 100644 > --- a/arch/arm/boot/dts/rk3288-tinker.dtsi > +++ b/arch/arm/boot/dts/rk3288-tinker.dtsi > @@ -254,6 +254,7 @@ > }; > > vccio_sd: LDO_REG5 { > + regulator-boot-on; > regulator-min-microvolt = <1800000>; > regulator-max-microvolt = <3300000>; > regulator-name = "vccio_sd"; > @@ -430,7 +431,7 @@ > bus-width = <4>; > cap-mmc-highspeed; > cap-sd-highspeed; > - card-detect-delay = <200>; > + broken-cd; > disable-wp; /* wp not hooked up */ > pinctrl-names = "default"; > pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_cd &sdmmc_bus4>; > _______________________________________________ Linux-rockchip mailing list Linux-rockchip@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/linux-rockchip
