High CPU load produced by USB (DW2)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 14 February 2018 at 13:07, Minas Harutyunyan
<Minas.Harutyunyan at synopsys.com> wrote:
> On 2/14/2018 12:57 PM, Mirza Krak wrote:
>> On 8 February 2018 at 14:53, Minas Harutyunyan
>> <Minas.Harutyunyan at synopsys.com> wrote:

< snip >

>
> I reviewed your interrupt count log again. About 140,000 interrupts in 2
> seconds, obviously it's not SOF only interrupts. More probably, its NAK
> respond interrupts to SSPLIT/CSPLIT transactions. For this case I can
> recommend you to apply patch from Douglas Anderson: "[PATCH v2] usb:
> dwc2: host: Don't retry NAKed transactions right away" which already
> merged to 4.16-rc1.
>
> In your setups you see different behavior on different HUBs. Your HUBs
> have different "TT think time": 8 and 32. In USB2.0 spec "TT think time"
> described as follow "TT requires at most 8/32 FS bit times of inter
> transaction gap on a full-/low-speed downstream bus". So, your "worst"
> HUB with "TT think time"=8 sending more frequently SSPLIT/CSPLIT
> transactions which replied by NAK. As result you see about 4 time more
> interrupts comparing to "good" HUB. Could you please check interrupts
> count for "good" HUB and check "4 time" hypothesis.

Did some further testing. The "good" HUB is actually as bad as the
"bad" HUB, and it was my setup that caused the different behavior. Did
not use the same devices etc.

Once I made sure that the configuration and setup was the same on both
board I could see that the behaved similarly. And that is the
following interrupt load:

- BT USB (FS) = ~80k interrupts / second
- Keyboard (FS) = ~80k interrupts / second
- WiFI USB (HS) = ~8k interrupts / second

After applying the suggested patch [1], it is steady around 8k
interrupts / second no matter what device I connect (HS/FS,
HUB/NO-HUB). Which is acceptable and usable.

Should this patch be a candidate for stable? Because in the current
state, this combination DWC2 + HS HUB + FS device, is not "usable".

[1]. https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/drivers/usb/dwc2?h=v4.16-rc1&id=38d2b5fb75c15923fb89c32134516a623515bce4

-- 
Med V?nliga H?lsningar / Best Regards

Mirza Krak



[Index of Archives]     [LM Sensors]     [Linux Sound]     [ALSA Users]     [ALSA Devel]     [Linux Audio Users]     [Linux Media]     [Kernel]     [Gimp]     [Yosemite News]     [Linux Media]

  Powered by Linux