If clk_set_rate() fails, we should disable clk before return.
Found by Linux Driver Verification project (linuxtesting.org).
Signed-off-by: Branislav Radocaj <branislav at radocaj.org>
---
Changes since v2:
* Improved inconsistent failure handling of clock rate setting
* For completeness of usecase, added arc_emac_probe error handling
---
drivers/net/ethernet/arc/emac_rockchip.c | 13 ++++++++++---
1 file changed, 10 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/arc/emac_rockchip.c b/drivers/net/ethernet/arc/emac_rockchip.c
index e278e3d96ee0..16f9bee992fe 100644
--- a/drivers/net/ethernet/arc/emac_rockchip.c
+++ b/drivers/net/ethernet/arc/emac_rockchip.c
@@ -199,9 +199,11 @@ static int emac_rockchip_probe(struct platform_device *pdev)
/* RMII interface needs always a rate of 50MHz */
err = clk_set_rate(priv->refclk, 50000000);
- if (err)
+ if (err) {
dev_err(dev,
"failed to change reference clock rate (%d)\n", err);
+ goto out_regulator_disable;
+ }
if (priv->soc_data->need_div_macclk) {
priv->macclk = devm_clk_get(dev, "macclk");
@@ -220,19 +222,24 @@ static int emac_rockchip_probe(struct platform_device *pdev)
/* RMII TX/RX needs always a rate of 25MHz */
err = clk_set_rate(priv->macclk, 25000000);
- if (err)
+ if (err) {
dev_err(dev,
"failed to change mac clock rate (%d)\n", err);
+ goto out_clk_disable_macclk;
+ }
}
err = arc_emac_probe(ndev, interface);
if (err) {
dev_err(dev, "failed to probe arc emac (%d)\n", err);
- goto out_regulator_disable;
+ goto out_clk_disable_macclk;
}
return 0;
+out_clk_disable_macclk:
+ if (priv->soc_data->need_div_macclk)
+ clk_disable_unprepare(priv->macclk);
out_regulator_disable:
if (priv->regulator)
regulator_disable(priv->regulator);
--
2.11.0
