If clk_set_rate() fails, we should disable clk
before return.
Found by Linux Driver Verification project (linuxtesting.org).
Signed-off-by: Branislav Radocaj <branislav at radocaj.org>
---
drivers/net/ethernet/arc/emac_rockchip.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/arc/emac_rockchip.c b/drivers/net/ethernet/arc/emac_rockchip.c
index e278e3d96ee0..c6163874e4e7 100644
--- a/drivers/net/ethernet/arc/emac_rockchip.c
+++ b/drivers/net/ethernet/arc/emac_rockchip.c
@@ -220,9 +220,11 @@ static int emac_rockchip_probe(struct platform_device *pdev)
/* RMII TX/RX needs always a rate of 25MHz */
err = clk_set_rate(priv->macclk, 25000000);
- if (err)
+ if (err) {
dev_err(dev,
"failed to change mac clock rate (%d)\n", err);
+ goto out_clk_disable_macclk;
+ }
}
err = arc_emac_probe(ndev, interface);
@@ -232,7 +234,8 @@ static int emac_rockchip_probe(struct platform_device *pdev)
}
return 0;
-
+out_clk_disable_macclk:
+ clk_disable_unprepare(priv->macclk);
out_regulator_disable:
if (priv->regulator)
regulator_disable(priv->regulator);
--
2.11.0
