Re: [PATCH v4 0/2] thermal: rcar_gen3: Improve reading calibration fuses

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 05/03/2025 18:46, Niklas Söderlund wrote:
Hello,

This small series aims to remove the code duplication that was added
when adding support for Gen4 devices. The logic to read the calibration
fuses are identical for Gen3 and Gen4, but the registers are at
different offsets.

Patch 1/2 is a small drive-by patch which fixes a style issue of the
constants found when working on the fuses code. While patch 2/2 is the
real work removing the code duplication.

It is tested on both Gen3 and Gen4 boards, but as not all boards have
the fused calibration values and the driver fallback to hard coded
values only Gen4 have really been tested as I don't have access to a
Gen3 board with fused calibration values.

Applied, thanks

--
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog




[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux