On Thu, Sep 26, 2024 at 1:24 PM Sean Anderson <sean.anderson@xxxxxxxxx> wrote: > > On 9/26/24 14:09, Sean Anderson wrote: > > Linux can configure almost every part of this clock generator without > > relying on the OTP settings. However, the correct configuration for the > > SD/OE pin cannot be determined automatically. Therefore, add the > > appropriate properties to configure this pin. > > > > I have CC'd some people who appear to have access to the following > > boards which use the versaclock5: > > > > - Salvator-X > > - HiHope RZ/G2[MN] Main Board > > - Beacon Embedded Works RZ/G2N Development Kit > > > > as I could not find schematics for these boards. You can help me out by > > (pick one): > > > > - Run the following command and send me the output: > > > > $ grep 10: /sys/kernel/debug/regmap/*-006a/registers Without any of the patches from this series, for the Beacon RZ/G2 Boards: grep 10: /sys/kernel/debug/regmap/*-006a/registers /sys/kernel/debug/regmap/2-006a/registers:10: a0 /sys/kernel/debug/regmap/4-006a/registers:10: a0 > > > > - Measure the voltage on the SD/OE pin on a functioning board. > > - Inspect (or send me) the schematic to determine the state of the SD/OE > > pin during normal operation. The SD/OE pins on the Beacon boards are not tied high by default. They have an optional pull-up resistor, but it is not populated by default. adam > > > > My suspicion is that all of these boards use the same configuration > > (SD/OE pin tied high) owing to their common design heritage. Thanks in > > advance. > > +CC the people I meant to CC in the first place
