On Thu, 9 May 2024 23:09:03 +0200 Niklas Söderlund wrote: > Add initial support for Renesas Ethernet-TSN End-station device of R-Car > V4H. The Ethernet End-station can connect to an Ethernet network using a > 10 Mbps, 100 Mbps, or 1 Gbps full-duplex link via MII/GMII/RMII/RGMII. > Depending on the connected PHY. > > The driver supports Rx checksum and offload and hardware timestamps. > > While full power management and suspend/resume is not yet supported the > driver enables runtime PM in order to enable the module clock. While > explicit clock management using clk_enable() would suffice for the > supported SoC, the module could be reused on SoCs where the module is > part of a power domain. I need to close net-next today, and I'm not sure if the discussion is fully concluded. So unfortunately this will have to wait for 6.11. If someone disagrees please shout. -- pw-bot: defer
