The design for this driver followed that of other Renesas Ethernet drivers and thus did not force a child-node for the MDIO bus. As there are no upstream drivers or users of this binding yet take the opportunity to correct this and force the usage of a child-node for the MDIO bus. Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx> --- Hello, Learn from the mistake made with the Renesas AVB bindings being worked on in [1] where no mdio node was used to describe the MDIO bus and the PHY was added directly as a child node to the AVB node. The Ethernet TSN driver is still in review and have not been merged and no usage of the bindings merged either. So while this breaks the binding it effects no one so we can correct this mistake without breaking any use-cases before we need to support any backward compatibility. 1. https://patchwork.kernel.org/project/netdevbpf/list/?series=834331 --- .../bindings/net/renesas,ethertsn.yaml | 33 ++++++++----------- 1 file changed, 14 insertions(+), 19 deletions(-) diff --git a/Documentation/devicetree/bindings/net/renesas,ethertsn.yaml b/Documentation/devicetree/bindings/net/renesas,ethertsn.yaml index ea35d19be829..0a88f4acc3f6 100644 --- a/Documentation/devicetree/bindings/net/renesas,ethertsn.yaml +++ b/Documentation/devicetree/bindings/net/renesas,ethertsn.yaml @@ -71,16 +71,8 @@ properties: enum: [0, 2000] default: 0 - '#address-cells': - const: 1 - - '#size-cells': - const: 0 - -patternProperties: - "^ethernet-phy@[0-9a-f]$": - type: object - $ref: ethernet-phy.yaml# + mdio: + $ref: /schemas/net/mdio.yaml# unevaluatedProperties: false required: @@ -94,8 +86,7 @@ required: - resets - phy-mode - phy-handle - - '#address-cells' - - '#size-cells' + - mdio additionalProperties: false @@ -122,14 +113,18 @@ examples: tx-internal-delay-ps = <2000>; phy-handle = <&phy3>; - #address-cells = <1>; - #size-cells = <0>; + mdio { + #address-cells = <1>; + #size-cells = <0>; - phy3: ethernet-phy@3 { - compatible = "ethernet-phy-ieee802.3-c45"; - reg = <0>; - interrupt-parent = <&gpio4>; - interrupts = <3 IRQ_TYPE_LEVEL_LOW>; reset-gpios = <&gpio1 23 GPIO_ACTIVE_LOW>; + reset-post-delay-us = <4000>; + + phy3: ethernet-phy@3 { + compatible = "ethernet-phy-ieee802.3-c45"; + reg = <0>; + interrupt-parent = <&gpio4>; + interrupts = <3 IRQ_TYPE_LEVEL_LOW>; + }; }; }; -- 2.44.0