Describe the two Marvel 88Q2110/QFN40 PHYs available on the R-Car V4H
White Hawk RAVB/Ethernet(1000Base-T1) sub-board. The two PHYs are wired
up on the board by default, there is no need to move any resistors which
are needed to access other PHYs available on this sub-board.
Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
---
* Changes since v1
- Correct typo in commit s/adv1/avb1/.
- Do not use underscores in node names.
- Move the MDIO bus properties into a septate child mdio node. This
change depends on updates to the driver and bindings posted
separately.
---
.../renesas/r8a779g0-white-hawk-ethernet.dtsi | 86 +++++++++++++++++++
1 file changed, 86 insertions(+)
diff --git a/arch/arm64/boot/dts/renesas/r8a779g0-white-hawk-ethernet.dtsi b/arch/arm64/boot/dts/renesas/r8a779g0-white-hawk-ethernet.dtsi
index 4f411f95c674..eb6030ed38b9 100644
--- a/arch/arm64/boot/dts/renesas/r8a779g0-white-hawk-ethernet.dtsi
+++ b/arch/arm64/boot/dts/renesas/r8a779g0-white-hawk-ethernet.dtsi
@@ -6,6 +6,50 @@
* Copyright (C) 2022 Glider bv
*/
+&avb1 {
+ pinctrl-0 = <&avb1_pins>;
+ pinctrl-names = "default";
+ phy-handle = <&phy1>;
+ status = "okay";
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ reset-gpios = <&gpio6 1 GPIO_ACTIVE_LOW>;
+ reset-post-delay-us = <4000>;
+
+ phy1: ethernet-phy@0 {
+ compatible = "ethernet-phy-ieee802.3-c45";
+ reg = <0>;
+ interrupt-parent = <&gpio6>;
+ interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
+ };
+ };
+};
+
+&avb2 {
+ pinctrl-0 = <&avb2_pins>;
+ pinctrl-names = "default";
+ phy-handle = <&phy2>;
+ status = "okay";
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ reset-gpios = <&gpio5 5 GPIO_ACTIVE_LOW>;
+ reset-post-delay-us = <4000>;
+
+ phy2: ethernet-phy@0 {
+ compatible = "ethernet-phy-ieee802.3-c45";
+ reg = <0>;
+ interrupt-parent = <&gpio5>;
+ interrupts = <4 IRQ_TYPE_LEVEL_LOW>;
+ };
+ };
+};
+
&i2c0 {
eeprom@53 {
compatible = "rohm,br24g01", "atmel,24c01";
@@ -14,3 +58,45 @@ eeprom@53 {
pagesize = <8>;
};
};
+
+&pfc {
+ avb1_pins: avb1 {
+ mux {
+ groups = "avb1_link", "avb1_mdio", "avb1_rgmii",
+ "avb1_txcrefclk";
+ function = "avb1";
+ };
+
+ mdio {
+ groups = "avb1_mdio";
+ drive-strength = <24>;
+ bias-disable;
+ };
+
+ rgmii {
+ groups = "avb1_rgmii";
+ drive-strength = <24>;
+ bias-disable;
+ };
+ };
+
+ avb2_pins: avb2 {
+ mux {
+ groups = "avb2_link", "avb2_mdio", "avb2_rgmii",
+ "avb2_txcrefclk";
+ function = "avb2";
+ };
+
+ mdio {
+ groups = "avb2_mdio";
+ drive-strength = <24>;
+ bias-disable;
+ };
+
+ rgmii {
+ groups = "avb2_rgmii";
+ drive-strength = <24>;
+ bias-disable;
+ };
+ };
+};
--
2.44.0
