On Fri, Mar 01, 2024 at 04:35:02PM +0100, Romain Gantois wrote: > There is a reocurring issue with stmmac controllers where the MAC fails to > initialize its hardware if an RX clock signal isn't provided on the MAC/PHY > link. > > This causes issues when PHY or PCS devices either go into suspend while > cutting the RX clock or do not bring the clock signal up early enough for > the MAC to initialize successfully. > > Set the mac_requires_rxc flag in the stmmac phylink config so that PHY/PCS > drivers know to keep the RX clock up at all times. > > Reported-by: Clark Wang <xiaoning.wang@xxxxxxx> > Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@xxxxxxx/ > Reported-by: Clément Léger <clement.leger@xxxxxxxxxxx> > Link: https://lore.kernel.org/linux-arm-kernel/20230116103926.276869-4-clement.leger@xxxxxxxxxxx/ > Suggested-by: Russell King <linux@xxxxxxxxxxxxxxx> This should be: Co-developed-by: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx> > Signed-off-by: Romain Gantois <romain.gantois@xxxxxxxxxxx> > --- > drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > index 79844dbe4258..2290f4808d7e 100644 > --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > @@ -1218,6 +1218,9 @@ static int stmmac_phy_setup(struct stmmac_priv *priv) > priv->phylink_config.type = PHYLINK_NETDEV; > priv->phylink_config.mac_managed_pm = true; > > + /* Stmmac always requires an RX clock for hardware initialization */ > + priv->phylink_config.mac_requires_rxc = true; > + > mdio_bus_data = priv->plat->mdio_bus_data; > if (mdio_bus_data) > priv->phylink_config.ovr_an_inband = > @@ -3408,6 +3411,10 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) > u32 chan; > int ret; > > + /* Make sure RX clock is enabled */ > + if (priv->hw->phylink_pcs) > + phylink_pcs_pre_init(priv->phylink, priv->hw->phylink_pcs); > + > /* DMA initialization and SW reset */ > ret = stmmac_init_dma_engine(priv); > if (ret < 0) { > > -- > 2.43.2 > > -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!