Hi All, > -----Original Message----- > From: Biju Das <biju.das.jz@xxxxxxxxxxxxxx> > Sent: Thursday, May 18, 2023 4:57 PM > To: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx> > Cc: Biju Das <biju.das.jz@xxxxxxxxxxxxxx>; Vinod Koul <vkoul@xxxxxxxxxx>; > Kishon Vijay Abraham I <kishon@xxxxxxxxxx>; linux-phy@xxxxxxxxxxxxxxxxxxx; > Geert Uytterhoeven <geert+renesas@xxxxxxxxx>; Fabrizio Castro > <fabrizio.castro.jz@xxxxxxxxxxx>; linux-renesas-soc@xxxxxxxxxxxxxxx > Subject: [PATCH RFC 0/3] Support VBUSEN selection control for RZ/G2L > > This patch series aims to add support for VBUSEN selection control for > RZ/G2L alike SoCs. > > As per RZ/G2L HW(Rev.1.30 May2023) manual, VBUSEN can be controlled by the > Port Power bit of the EHCI/OHCI operational register or by the VBOUT bit > of the VBUS Control Register. > > A reset consumer(phy-rcar-gen3-usb2) needs to find the reset controller > device and then call the provider(reset-rzg2l-usbphy-ctrl) to configure > it. > > Please share your thoughts on this patch series. Gentle ping for this RFC series. Is this series is in the right direction? Cheers, Biju > > Biju Das (3): > reset: Add reset_controller_get_dev() > reset: renesas: Add rzg2l_usbphy_ctrl_select_vbus_ctrl() > phy: renesas: phy-rcar-gen3-usb2: Control VBUSEN selection > > drivers/phy/renesas/phy-rcar-gen3-usb2.c | 9 ++++++++ > drivers/reset/core.c | 14 ++++++++++++ > drivers/reset/reset-rzg2l-usbphy-ctrl.c | 27 ++++++++++++++++++++++++ > include/linux/reset-controller.h | 9 ++++++++ > include/linux/reset/rzg2l-usbphy-ctrl.h | 16 ++++++++++++++ > 5 files changed, 75 insertions(+) > create mode 100644 include/linux/reset/rzg2l-usbphy-ctrl.h > > -- > 2.25.1
