From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx> In hardware manual of RZ/G2L (r01uh0914ej0130-rzg2l-rzg2lc.pdf) is available the following statement with regards to clearing interrupts though ISCR register: [Write operation] When "Falling-edge detection", "Rising-edge detection" or "Falling/Rising-edge detection" is set in ISCR.: - In case ISTAT is 1 0: IRQn interrupt detection status is cleared. 1: Invalid to write. - In case ISTAT is 0 Invalid to write. When “Low-level detection” is set in IITSR.: Invalid to write. Thus, take into account interrupt type when clearing interrupts though ISCR register. Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx> --- drivers/irqchip/irq-renesas-rzg2l.c | 14 ++++++++++---- 1 file changed, 10 insertions(+), 4 deletions(-) diff --git a/drivers/irqchip/irq-renesas-rzg2l.c b/drivers/irqchip/irq-renesas-rzg2l.c index 9ce0d6d67486..1ed9cb7178fa 100644 --- a/drivers/irqchip/irq-renesas-rzg2l.c +++ b/drivers/irqchip/irq-renesas-rzg2l.c @@ -73,11 +73,17 @@ static void rzg2l_irq_eoi(struct irq_data *d) unsigned int hw_irq = irqd_to_hwirq(d) - IRQC_IRQ_START; struct rzg2l_irqc_priv *priv = irq_data_to_priv(d); u32 bit = BIT(hw_irq); - u32 reg; + u32 iitsr, iscr; - reg = readl_relaxed(priv->base + ISCR); - if (reg & bit) - writel_relaxed(reg & ~bit, priv->base + ISCR); + iscr = readl_relaxed(priv->base + ISCR); + iitsr = readl_relaxed(priv->base + IITSR); + + /* + * ISCR could be cleared only if type is falling-edge, rising-edge or + * falling/rising-edge. + */ + if ((iscr & bit) && (iitsr & IITSR_IITSEL_MASK(hw_irq))) + writel_relaxed(iscr & ~bit, priv->base + ISCR); } static void rzg2l_tint_eoi(struct irq_data *d) -- 2.39.2
