On Fri, Aug 18, 2023 at 8:35 AM Biju Das <biju.das.jz@xxxxxxxxxxxxxx> wrote:
>
> Hi Adam Ford,
>
> Thanks for the feedback.
>
> > Subject: Re: [PATCH 7/7] drm: adv7511: Add hpd_override_enable feature bit
> > to struct adv7511_chip_info
> >
> > On Sun, Aug 13, 2023 at 1:06 PM Biju Das <biju.das.jz@xxxxxxxxxxxxxx>
> > wrote:
> > >
> > > As per spec, it is allowed to pulse the HPD signal to indicate that
> > > the EDID information has changed. Some monitors do this when they wake
> > > up from standby or are enabled. When the HPD goes low the adv7511 is
> > > reset and the outputs are disabled which might cause the monitor to go
> > > to standby again. To avoid this we ignore the HPD pin for the first
> > > few seconds after enabling the output. On the other hand,
> > > adv7535 require to enable HPD Override bit for proper HPD.
> > >
> > > Add hpd_override_enable feature bit to struct adv7511_chip_info to
> > > handle this scenario.
> > >
> > > While at it, drop the enum adv7511_type as it is unused.
> >
> > It seems like dropping adv7511_type is unrelated to the rest of the patch,
> > and I think it should be split from this into its own patch
>
> With this patch, there is no user for adv7511_type that is the
> reason it is added here. I thought that is the common practice.
>
I wasn't sure.
> Please correct me if that is not the case.
I'll defer to the maintainers. In general I like the series because
it reduces the number of compare evaluations. I'll try to run some
tests on a board that I have with a adv7535 this weekend.
adam
>
> Cheers,
> Biju
>
> >
> > adam
> > >
> > > Signed-off-by: Biju Das <biju.das.jz@xxxxxxxxxxxxxx>
> > > ---
> > > drivers/gpu/drm/bridge/adv7511/adv7511.h | 8 +-------
> > > drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 12 +++++-------
> > > 2 files changed, 6 insertions(+), 14 deletions(-)
> > >
> > > diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > index 627531f48f84..c523ac4c9bc8 100644
> > > --- a/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > +++ b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > @@ -325,22 +325,16 @@ struct adv7511_video_config {
> > > struct hdmi_avi_infoframe avi_infoframe; };
> > >
> > > -enum adv7511_type {
> > > - ADV7511,
> > > - ADV7533,
> > > - ADV7535,
> > > -};
> > > -
> > > #define ADV7511_MAX_ADDRS 3
> > >
> > > struct adv7511_chip_info {
> > > - enum adv7511_type type;
> > > unsigned long max_mode_clock;
> > > unsigned long max_lane_freq;
> > > const char * const *supply_names;
> > > unsigned int num_supplies;
> > > unsigned has_dsi:1;
> > > unsigned link_config:1;
> > > + unsigned hpd_override_enable:1;
> > > };
> > >
> > > struct adv7511 {
> > > diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > index 6974c267b1d5..7b06a0a21685 100644
> > > --- a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > +++ b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > @@ -354,7 +354,7 @@ static void __adv7511_power_on(struct adv7511
> > *adv7511)
> > > * first few seconds after enabling the output. On the other hand
> > > * adv7535 require to enable HPD Override bit for proper HPD.
> > > */
> > > - if (adv7511->info->type == ADV7535)
> > > + if (adv7511->info->hpd_override_enable)
> > > regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
> > > ADV7535_REG_POWER2_HPD_OVERRIDE,
> > > ADV7535_REG_POWER2_HPD_OVERRIDE);
> > > @@ -381,7 +381,7 @@ static void adv7511_power_on(struct adv7511
> > > *adv7511) static void __adv7511_power_off(struct adv7511 *adv7511) {
> > > /* TODO: setup additional power down modes */
> > > - if (adv7511->info->type == ADV7535)
> > > + if (adv7511->info->hpd_override_enable)
> > > regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
> > > ADV7535_REG_POWER2_HPD_OVERRIDE,
> > > 0);
> > >
> > > @@ -682,7 +682,7 @@ adv7511_detect(struct adv7511 *adv7511, struct
> > drm_connector *connector)
> > > status = connector_status_disconnected;
> > > } else {
> > > /* Renable HPD sensing */
> > > - if (adv7511->info->type == ADV7535)
> > > + if (adv7511->info->hpd_override_enable)
> > > regmap_update_bits(adv7511->regmap,
> > ADV7511_REG_POWER2,
> > >
> > ADV7535_REG_POWER2_HPD_OVERRIDE,
> > >
> > > ADV7535_REG_POWER2_HPD_OVERRIDE); @@ -1360,14 +1360,12 @@ static void
> > > adv7511_remove(struct i2c_client *i2c) }
> > >
> > > static const struct adv7511_chip_info adv7511_chip_info = {
> > > - .type = ADV7511,
> > > .supply_names = adv7511_supply_names,
> > > .num_supplies = ARRAY_SIZE(adv7511_supply_names),
> > > .link_config = 1
> > > };
> > >
> > > static const struct adv7511_chip_info adv7533_chip_info = {
> > > - .type = ADV7533,
> > > .max_mode_clock = 80000,
> > > .max_lane_freq = 800000,
> > > .supply_names = adv7533_supply_names, @@ -1376,12 +1374,12 @@
> > > static const struct adv7511_chip_info adv7533_chip_info = { };
> > >
> > > static const struct adv7511_chip_info adv7535_chip_info = {
> > > - .type = ADV7535,
> > > .max_mode_clock = 148500,
> > > .max_lane_freq = 891000,
> > > .supply_names = adv7533_supply_names,
> > > .num_supplies = ARRAY_SIZE(adv7533_supply_names),
> > > - .has_dsi = 1
> > > + .has_dsi = 1,
> > > + .hpd_override_enable = 1
> > > };
> > >
> > > static const struct i2c_device_id adv7511_i2c_ids[] = {
> > > --
> > > 2.25.1
> > >
