On 12/07/2023 13:37, Wolfram Sang wrote: > Needed to enable this chip on a Renesas KingFisher board. Description > copied over from the Mediatek driver which already supports it. > > Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx> > --- > Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml b/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml > index 4835a280b3bf..8f6992b97ca6 100644 > --- a/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml > +++ b/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml > @@ -41,6 +41,12 @@ properties: > description: > > Backup voltage regulator > > + reset-gpios: > + maxItems: 1 > + description: > > + An optional reset line, with names such as RESET or NRESET. > + If the line is active low it should be flagged with GPIO_ACTIVE_LOW. > + > required: > - compatible > - vcc-supply > @@ -54,5 +60,6 @@ examples: > compatible = "u-blox,neo-8"; > v-bckp-supply = <&gnss_v_bckp_reg>; > vcc-supply = <&gnss_vcc_reg>; > + reset-gpios = <&gpio 1 GPIO_ACTIVE_LOW>; This should complain with errors, because of missing header for the defines, so usual disclaimer: It does not look like you tested the bindings, at least after quick look. Please run `make dt_binding_check` (see Documentation/devicetree/bindings/writing-schema.rst for instructions). Maybe you need to update your dtschema and yamllint. Best regards, Krzysztof
