[PATCH RFT] mmc: renesas_sdhi: register irqs before registering controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



IRQs should be ready to serve when we call mmc_add_host() via
tmio_mmc_host_probe(). To achieve that, ensure that all irqs are masked
before registering the handlers.

Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>
---

Based on 6.5-rc1 with bf54dec9e953 ("Revert "mmc: Revert "mmc: core:
Allow mmc_start_host() synchronously detect a card") reverted. That base
alone shows the regression. This patch works fine on a Salvator-X with a
M3-W. I'll test more boards. Yet, I send it out so people can tests with
boards I don't have.

 drivers/mmc/host/renesas_sdhi_core.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c
index 345934e4f59e..499d043f034f 100644
--- a/drivers/mmc/host/renesas_sdhi_core.c
+++ b/drivers/mmc/host/renesas_sdhi_core.c
@@ -1004,10 +1004,11 @@ int renesas_sdhi_probe(struct platform_device *pdev,
 		host->ops.start_signal_voltage_switch =
 			renesas_sdhi_start_signal_voltage_switch;
 		host->sdcard_irq_setbit_mask = TMIO_STAT_ALWAYS_SET_27;
-		host->sdcard_irq_mask_all = TMIO_MASK_ALL_RCAR2;
 		host->reset = renesas_sdhi_reset;
 	}
 
+	host->sdcard_irq_mask_all = TMIO_MMC_MIN_RCAR2 ? TMIO_MASK_ALL_RCAR2 : TMIO_MASK_ALL;
+
 	/* Orginally registers were 16 bit apart, could be 32 or 64 nowadays */
 	if (!host->bus_shift && resource_size(res) > 0x100) /* old way to determine the shift */
 		host->bus_shift = 1;
@@ -1100,9 +1101,7 @@ int renesas_sdhi_probe(struct platform_device *pdev,
 		host->ops.hs400_complete = renesas_sdhi_hs400_complete;
 	}
 
-	ret = tmio_mmc_host_probe(host);
-	if (ret < 0)
-		goto edisclk;
+	sd_ctrl_write32_as_16_and_16(host, CTL_IRQ_MASK, host->sdcard_irq_mask_all);
 
 	num_irqs = platform_irq_count(pdev);
 	if (num_irqs < 0) {
@@ -1129,6 +1128,10 @@ int renesas_sdhi_probe(struct platform_device *pdev,
 			goto eirq;
 	}
 
+	ret = tmio_mmc_host_probe(host);
+	if (ret < 0)
+		goto edisclk;
+
 	dev_info(&pdev->dev, "%s base at %pa, max clock rate %u MHz\n",
 		 mmc_hostname(host->mmc), &res->start, host->mmc->f_max / 1000000);
 
-- 
2.35.1




[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux