Re: [PATCH v2] dt-bindings: i2c: maxim,max96712: Require setting bus-type property

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 09/05/2023 21:00, Niklas Söderlund wrote:
> The MAX96712 can support both a CSI-2 C-PHY and D-PHY bus. The initial
> staging driver however only supported D-PHY and the bus-type property
> was left optional.
> 
> In preparation for adding C-PHY support to the staging driver make the
> bus-type property mandatory as it is needed to select the correct PHY
> mode. Without the bus-type property present, the driver falls-back to
> D-PHY mode, so the change is functionally backward compatible with old
> DTS files lacking the property.
> 
> The only in-tree DTS file (renesas/r8a779a0-falcon-csi-dsi.dtsi) that
> lacked the property uses D-PHY and have been updated.
> 
> Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> ---
> * Changes since v1
> - Use symbolic names in comments for the bus-type properties.
> - Improve the commit message.
> - Rebased to v6.4-rc1.
> ---
>  .../devicetree/bindings/media/i2c/maxim,max96712.yaml      | 7 +++++++
>  1 file changed, 7 insertions(+)
> 


Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

Best regards,
Krzysztof




[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux