After system entered Suspend to RAM, registers setting of this
hardware is resetted because the SoC will be turned off. On R-Car Gen3
(info->ccc_gac), ravb_ptp_init() is called in ravb_probe() only. So,
after system resumed, it lacks of the initial settings for ptp. So,
add ravb_ptp_{init,stop}() into ravb_{resume,suspend}().
Fixes: f5d7837f96e5 ("ravb: ptp: Add CONFIG mode support")
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
---
drivers/net/ethernet/renesas/ravb_main.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/net/ethernet/renesas/ravb_main.c b/drivers/net/ethernet/renesas/ravb_main.c
index b4e0fc7f65bd..3f61100c02f4 100644
--- a/drivers/net/ethernet/renesas/ravb_main.c
+++ b/drivers/net/ethernet/renesas/ravb_main.c
@@ -2973,6 +2973,9 @@ static int __maybe_unused ravb_suspend(struct device *dev)
else
ret = ravb_close(ndev);
+ if (priv->info->ccc_gac)
+ ravb_ptp_stop(ndev);
+
return ret;
}
@@ -3011,6 +3014,9 @@ static int __maybe_unused ravb_resume(struct device *dev)
/* Restore descriptor base address table */
ravb_write(ndev, priv->desc_bat_dma, DBAT);
+ if (priv->info->ccc_gac)
+ ravb_ptp_init(ndev, priv->pdev);
+
if (netif_running(ndev)) {
if (priv->wol_enabled) {
ret = ravb_wol_restore(ndev);
--
2.25.1
