On Fri, Dec 02, 2022 at 02:56:01PM +0100, Geert Uytterhoeven wrote:
> Hi Michael,
>
> On Fri, Dec 2, 2022 at 2:50 PM Michael Walle <michael@xxxxxxxx> wrote:
> > Am 2022-12-02 14:37, schrieb Geert Uytterhoeven:
> > > Document support for the Micron MT25QU256A and MT25QU512A Serial NOR
> > > FLASHes.
> > >
> > > Merge the new entries with the existing entry for MT25QU02G.
> > >
> > > Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
> > > ---
> > > mt25qu512a is already in active use, causing "make dtbs_check" errors.
> > > mt25qu256a is supported by the Linux spi-nor driver, but there are no
> > > upstream users yet.
> >
> > Is it encouraged to use the specific compatible with SPI-NOR flashes?
> > As far as I know it isn't. The spi-nor subsys tries hard to identify
> > any flashes at runtime and any additional information in the device tree
> > is used as a last resort (just for flashes which doesn't support the
> > read jedec id command yet). And usually boards have different sources
> > for flash chips, so hardcoding a particular part in the device tree
> > doesn't make sense.
>
> Thanks, I am aware there have been pushbacks when trying to
> document more compatible values.
>
> IMHO either all or none of them should be documented.
> If device-specific compatible values are discouraged, the bindings
> should be updated to reflect that, and document a single compatible
> value ("jedec,spi-nor") only.
That's already allowed, so there's your answer.
The caveat is don't be adding them later to your DT when you find an
issue and new quirk properties will probably be rejected.
Rob
