Hi Wolfram,
Thanks for your work.
On 2022-06-10 22:04:59 +0200, Wolfram Sang wrote:
> When setting up a new board, a plain "Can't register thermal zone"
> didn't help me much because the thermal zones in DT were all fine. I
> just had a sensor entry too much in the parent TSC node. Reword the
> failure/success messages to contain the sensor number to make it easier
> to understand which sensor is affected. Example output now:
>
> rcar_gen3_thermal e6198000.thermal: Sensor 0: Loaded 1 trip points
> rcar_gen3_thermal e6198000.thermal: Sensor 1: Loaded 1 trip points
> rcar_gen3_thermal e6198000.thermal: Sensor 2: Loaded 1 trip points
> rcar_gen3_thermal e6198000.thermal: Sensor 3: Can't register thermal zone
>
> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>
Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> ---
>
> Change since v2:
>
> * don't add plural-'s' at runtime to allow for a greppable string
> (Thanks, Niklas!)
>
> drivers/thermal/rcar_gen3_thermal.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/thermal/rcar_gen3_thermal.c b/drivers/thermal/rcar_gen3_thermal.c
> index ccdf8a24ddc7..cda7c52f2319 100644
> --- a/drivers/thermal/rcar_gen3_thermal.c
> +++ b/drivers/thermal/rcar_gen3_thermal.c
> @@ -511,7 +511,7 @@ static int rcar_gen3_thermal_probe(struct platform_device *pdev)
> zone = devm_thermal_zone_of_sensor_register(dev, i, tsc,
> &rcar_gen3_tz_of_ops);
> if (IS_ERR(zone)) {
> - dev_err(dev, "Can't register thermal zone\n");
> + dev_err(dev, "Sensor %u: Can't register thermal zone\n", i);
> ret = PTR_ERR(zone);
> goto error_unregister;
> }
> @@ -533,7 +533,7 @@ static int rcar_gen3_thermal_probe(struct platform_device *pdev)
> if (ret < 0)
> goto error_unregister;
>
> - dev_info(dev, "TSC%u: Loaded %d trip points\n", i, ret);
> + dev_info(dev, "Sensor %u: Loaded %d trip points\n", i, ret);
> }
>
> if (!priv->num_tscs) {
> --
> 2.35.1
>
--
Kind Regards,
Niklas Söderlund
