The support the external role switch a variety of situations were
addressed, but the transition from USB_ROLE_HOST to USB_ROLE_NONE
leaves the host up which can cause some error messages when
switching from host to none, to gadget, to none, and then back
to host again.
xhci-hcd ee000000.usb: Abort failed to stop command ring: -110
xhci-hcd ee000000.usb: xHCI host controller not responding, assume dead
xhci-hcd ee000000.usb: HC died; cleaning up
usb 4-1: device not accepting address 6, error -108
usb usb4-port1: couldn't allocate usb_device
After this happens it will not act as a host again.
Fix this by releasing the host mode when transitioning to USB_ROLE_NONE.
Fixes: 0604160d8c0b ("usb: gadget: udc: renesas_usb3: Enhance role switch support")
Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
diff --git a/drivers/usb/gadget/udc/renesas_usb3.c b/drivers/usb/gadget/udc/renesas_usb3.c
index 57d417a7c3e0..601829a6b4ba 100644
--- a/drivers/usb/gadget/udc/renesas_usb3.c
+++ b/drivers/usb/gadget/udc/renesas_usb3.c
@@ -2378,6 +2378,8 @@ static void handle_ext_role_switch_states(struct device *dev,
switch (role) {
case USB_ROLE_NONE:
usb3->connection_state = USB_ROLE_NONE;
+ if (cur_role == USB_ROLE_HOST)
+ device_release_driver(host);
if (usb3->driver)
usb3_disconnect(usb3);
usb3_vbus_out(usb3, false);
--
2.32.0
