Hi, This series touches up how the R-Car CSI-2 driver traverse and parse DT device nodes. Patch 1/2 switches to only use the fwnode interface and 2/2 specifies the bus type used for parsing. This is done a preparation to later modify the rcar-vin driver in a similar fashion to be able to drop the use of the v4l2_async_notifier_parse_fwnode_endpoints_by_port() helper which I understand is marked for deprecation. Therefore comments on the over all solution of parsing DT here would be appreciated. Niklas Söderlund (2): rcar-csi2: Switch to using fwnode instead of OF rcar-csi2: Set bus type when parsing fwnode drivers/media/platform/rcar-vin/rcar-csi2.c | 18 ++++++++++-------- 1 file changed, 10 insertions(+), 8 deletions(-) -- 2.28.0
