Document endpoint properties required for parallel interface
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
---
.../devicetree/bindings/media/i2c/ov772x.txt | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/Documentation/devicetree/bindings/media/i2c/ov772x.txt b/Documentation/devicetree/bindings/media/i2c/ov772x.txt
index 0b3ede5b8e6a..1f4153484717 100644
--- a/Documentation/devicetree/bindings/media/i2c/ov772x.txt
+++ b/Documentation/devicetree/bindings/media/i2c/ov772x.txt
@@ -21,6 +21,22 @@ subnode for its digital output video port, in accordance with the video
interface bindings defined in Documentation/devicetree/bindings/media/
video-interfaces.txt.
+Endpoint node required properties for parallel connection are:
+- remote-endpoint: a phandle to the bus receiver's endpoint node.
+- bus-width: shall be set to <8> for 8 bits parallel bus
+ or <10> for 10 bits parallel bus
+- data-shift: shall be set to <2> for 8 bits parallel bus
+ (lines 9:2 are used) or <0> for 10 bits parallel bus
+- hsync-active: active state of the HSYNC signal, 0/1 for LOW/HIGH respectively.
+ (Not required for bus-type equal 6)
+- vsync-active: active state of the VSYNC signal, 0/1 for LOW/HIGH respectively.
+ (Not required for bus-type equal 6)
+- pclk-sample: sample data on rising (1) or falling (0) edge of the pixel clock
+ signal. (Not required for bus-type equal 6)
+- bus-type: data bus type. Possible values are:
+ 5 - Parallel
+ 6 - Bt.656
+
Example:
&i2c0 {
--
2.17.1
