Introduce two new pad operations to allow retrieving and configuring the
media bus parameters on a subdevice pad.
The newly introduced operations aims to replace the s/g_mbus_config video
operations, which have been on their way for deprecation since a long
time.
Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
---
include/media/v4l2-subdev.h | 27 +++++++++++++++++++++++++++
1 file changed, 27 insertions(+)
diff --git a/include/media/v4l2-subdev.h b/include/media/v4l2-subdev.h
index f7fe78a6f65a..90d9dfa92cf0 100644
--- a/include/media/v4l2-subdev.h
+++ b/include/media/v4l2-subdev.h
@@ -670,6 +670,29 @@ struct v4l2_subdev_pad_config {
*
* @set_frame_desc: set the low level media bus frame parameters, @fd array
* may be adjusted by the subdev driver to device capabilities.
+ *
+ * @get_mbus_config: get the media bus configuration of a remote sub-device.
+ * The media bus configuration is usually retrieved from the
+ * firmware interface at sub-device probe time, immediately
+ * applied to the hardware and eventually adjusted by the
+ * driver. Remote sub-devices (usually video receivers) shall
+ * use this operation to query the transmitting end bus
+ * configuration in order to adjust their own one accordingly.
+ * Callers should make sure they get the most up-to-date as
+ * possible configuration from the remote end, likely calling
+ * this operation as close as possible to stream on time. The
+ * operation is allowed to fail if the pad index it has been
+ * called on is not valid.
+ *
+ * @set_mbus_config: set the media bus configuration of a remote sub-device.
+ * This operations is intended to allow, in combination with
+ * the get_mbus_config operation, the negotiation of media bus
+ * configuration parameters between media sub-devices. The
+ * operation shall not fail if the requested configuration is
+ * not supported, but the driver shall update the content of
+ * the %config argument to reflect what has been actually
+ * applied to the hardware. The operation is allowed to fail
+ * if the pad index it has been called on is not valid.
*/
struct v4l2_subdev_pad_ops {
int (*init_cfg)(struct v4l2_subdev *sd,
@@ -710,6 +733,10 @@ struct v4l2_subdev_pad_ops {
struct v4l2_mbus_frame_desc *fd);
int (*set_frame_desc)(struct v4l2_subdev *sd, unsigned int pad,
struct v4l2_mbus_frame_desc *fd);
+ int (*get_mbus_config)(struct v4l2_subdev *sd, unsigned int pad,
+ struct v4l2_mbus_config *config);
+ int (*set_mbus_config)(struct v4l2_subdev *sd, unsigned int pad,
+ struct v4l2_mbus_config *config);
};
/**
--
2.27.0
