Hi Chris,
On Wed, Dec 4, 2019 at 2:31 PM Chris Brandt <Chris.Brandt@xxxxxxxxxxx> wrote:
> > To avoid future problems, you probably do want to specify spi-tx-bus-width =
> > <4> and spi-rx-bus-width = <4> in DTS now.
>
> I didn't do that because if the MTD layer then thinks I 'want' to do 4-bit access, then that introduces a new problem the solve.
> The MTD layer might start sending down QUAD READ commands to the external SPI and then the SPI Flash will start sending back data on all 4 lines, but the controller is only configured for 1-bit transfers.
>
> I honestly don't know when/why the MTD layer decides on switch from 1-bit to 4-bit mode, so while the board hardware is wired for 4-bit (as the DT would document), we are not ready to be doing 4-bit just yet.
> I just want to try and get the driver in at first....then we can make it do fancy stuff later.
>
> If someone can tell me that even if "spi-rx-bus-width = <4>" is put I the board DTS, the spi will still only do 1-bit transfers until the application specially enables 4-bit mode, then I'm fine with add bus-width=<4> in the DTS.
Your spibsc driver does:
master->mode_bits = SPI_CPOL | SPI_CPHA;
i.e. SPI_[TR]X_{QUAD,DUAL} are not set, so it should not try those modes.
At least on RSK+RZA1, the FLASHes are wired in quad mode, so you
should describe the hardware in DT.
>
> Unless....I did not understand you meaning....
>
> Did you mean put 'spi-rx-bus-width = <4>' in the .dtsi???? (then I can override it back to <1> that in the board .dts)???
No, in the board .dtb.
> > BTW, when using spibsc in direct-mapped mode: if you turn of and on again the
> > module clock, does the spibsc need reprogramming?
>
> Nope. Everything will stay the same (just like all the other peripherals). The only thing you 'might' want to do is flush the read cache (especially if you disconnected it because you were going to go out and re-write some of the flash in SPI mode).
Good. So that means the MTD driver can be modular. Unused clocks are
turned off at boot, and can be turned on when the mtd-rom driver is loaded
and activated.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
