This patch enables WLAN support for the HiHope RZ/G2[MN] boards.
Signed-off-by: Biju Das <biju.das@xxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/renesas/hihope-common.dtsi | 45 ++++++++++++++++++++++++++
1 file changed, 45 insertions(+)
diff --git a/arch/arm64/boot/dts/renesas/hihope-common.dtsi b/arch/arm64/boot/dts/renesas/hihope-common.dtsi
index fdeb4d2..52d61c9 100644
--- a/arch/arm64/boot/dts/renesas/hihope-common.dtsi
+++ b/arch/arm64/boot/dts/renesas/hihope-common.dtsi
@@ -54,6 +54,13 @@
led3 {
gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
};
+
+ wlan_active_led {
+ label = "yellow:wlan";
+ gpios = <&gpio7 1 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "phy0tx";
+ default-state = "off";
+ };
};
reg_1p8v: regulator0 {
@@ -98,6 +105,17 @@
1800000 0>;
};
+ wlan_en_reg: regulator-wlan_en {
+ compatible = "regulator-fixed";
+ regulator-name = "wlan-en-regulator";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ startup-delay-us = <70000>;
+
+ gpio = <&gpio_expander 1 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
x302_clk: x302-clock {
compatible = "fixed-clock";
#clock-cells = <0>;
@@ -242,6 +260,12 @@
power-source = <1800>;
};
+ sdhi2_pins: sd2 {
+ groups = "sdhi2_data4", "sdhi2_ctrl";
+ function = "sdhi2";
+ power-source = <1800>;
+ };
+
sdhi3_pins: sd3 {
groups = "sdhi3_data8", "sdhi3_ctrl", "sdhi3_ds";
function = "sdhi3";
@@ -301,6 +325,27 @@
status = "okay";
};
+&sdhi2 {
+ status = "okay";
+ pinctrl-0 = <&sdhi2_pins>;
+ pinctrl-names = "default";
+
+ vmmc-supply = <&wlan_en_reg>;
+ bus-width = <4>;
+ non-removable;
+ cap-power-off-card;
+ keep-power-in-suspend;
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+ wlcore: wlcore@2 {
+ compatible = "ti,wl1837";
+ reg = <2>;
+ interrupt-parent = <&gpio2>;
+ interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
+ };
+};
+
&sdhi3 {
pinctrl-0 = <&sdhi3_pins>;
pinctrl-1 = <&sdhi3_pins>;
--
2.7.4
