[PATCH 0/5] ARM: rskrza1: Add RZ/A1 IRQC and input switches

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



	Hi all,

Unlike on most other Renesas SoCs, the GPIO controller block on RZ/A1
SoCs lack interrupt functionality.  While the GPIOs can be routed to the
GIC as pin interrupts, this is of limited use, as the PL390 GIC supports
rising edge and high-level interrupts only.

Fortunately RZ/A1 SoCs contain a small front-end for the GIC, allowing
to use up to 8 external interrupts, with configurable sense select.

Hence this patch series adds DT bindings and a driver for this
front-end, adds a device node for it in the RZ/A1H DTS, and uses it to
enable support for the 3 input switches on the Renesas RSK+RZA1
development board.

I expect this driver to be reusable for RZ/A2, after adding a match
entry with .gic_spi_base = 4.
  - Should this information come from DT instead?
  - Originally I had interrupts properties in DT to define the mapping
    from external interrupts to GIC interrupts (cfr. "renesas,irqc",
    which also calls request_irq()), but other similar drivers seem to
    hardcode this information in the driver, so I went that route.

Dependencies:
  - Patch 3 depends on patch 2,
  - Patch 4 can be applied as soon as the DT bindings in patch 1 have
    been accepted,
  - Patch 5 depends on patch 4.

This has been tested on RSK+RZA1 with evtest and s2ram wake-up.
I have verified proper operation of low-level and rising/falling sense
select, too.

Thanks for your comments!

Geert Uytterhoeven (5):
  dt-bindings: interrupt-controller: Add Renesas RZ/A1 Interrupt
    Controller
  irqchip: Add Renesas RZ/A1 Interrupt Controller driver
  soc: renesas: Enable RZ/A1 IRQC on RZ/A1H
  ARM: dts: r7s72100: Add IRQC device node
  ARM: dts: rskrza1: Add input switches

 .../renesas,rza1-irqc.txt                     |  27 ++
 arch/arm/boot/dts/r7s72100-rskrza1.dts        |  38 +++
 arch/arm/boot/dts/r7s72100.dtsi               |   8 +
 drivers/irqchip/Kconfig                       |   4 +
 drivers/irqchip/Makefile                      |   1 +
 drivers/irqchip/irq-renesas-rza1.c            | 238 ++++++++++++++++++
 drivers/soc/renesas/Kconfig                   |   1 +
 7 files changed, 317 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/renesas,rza1-irqc.txt
 create mode 100644 drivers/irqchip/irq-renesas-rza1.c

-- 
2.17.1

Gr{oetje,eeting}s,

						Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
							    -- Linus Torvalds



[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux