On 11/19/2018 12:03 AM, Wolfram Sang wrote: > On Sun, Nov 18, 2018 at 06:34:24PM +0100, Marek Vasut wrote: >> This patch adds CAN0,1 and CANFD device nodes for the r8a77990 SoC >> and enables CANFD connected to CN10 on the E3 Ebisu board using the >> R8A77990 SoC. >> >> Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxx> >> Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> >> Cc: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> >> Cc: Rob Herring <robh@xxxxxxxxxx> >> Cc: Simon Horman <horms+renesas@xxxxxxxxxxxx> >> Cc: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx> >> Cc: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> >> Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx >> Cc: linux-renesas-soc@xxxxxxxxxxxxxxx > > Same here, what was tested? I connected the CN10 to Peak CANFD, brought both interfaces up at 125kBd/250kBd for FD $ ip link set canX up type can bitrate 125000 dbitrate 250000 fd on And ran on either side: $ cangen -m canX and $ candump -t d -dex canX This should give a good mix of CAN messages. -- Best regards, Marek Vasut
