[PATCH v2 2/3] arm64: dts: renesas: salvator-common: Configure PMIC for DDR Backup Power

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Salvator-X(S), all of the DDR0, DDR1, DDR0C, and DDR1C power rails
need to be kept powered when backup mode is enabled.  Reflect this in
the "rohm,ddr-backup-power" property for the BD9571MWV PMIC node.

The accessory power switch (SW23) is a toggle switch, hense specify
"rohm,rstbmode-level".

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
v2:
  - Add rohm,rstbmode-level.
---
 arch/arm64/boot/dts/renesas/salvator-common.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/renesas/salvator-common.dtsi b/arch/arm64/boot/dts/renesas/salvator-common.dtsi
index 2a7f36abd2dd85c6..80794c38c2669d75 100644
--- a/arch/arm64/boot/dts/renesas/salvator-common.dtsi
+++ b/arch/arm64/boot/dts/renesas/salvator-common.dtsi
@@ -376,6 +376,8 @@
 		#interrupt-cells = <2>;
 		gpio-controller;
 		#gpio-cells = <2>;
+		rohm,ddr-backup-power = <15>;
+		rohm,rstbmode-level;
 
 		regulators {
 			dvfs: dvfs {
-- 
2.7.4




[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux