On Tue, Feb 13, 2018 at 02:24:14PM +0300, Sergei Shtylyov wrote:
> Specify EtherAVB PHY IRQ in the Eagle board's device tree, now that we
> have the GPIO support (previously phylib had to resort to polling).
>
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov@xxxxxxxxxxxxxxxxxx>
Thanks, applied with Geert's tag.
> ---
> arch/arm64/boot/dts/renesas/r8a77970-eagle.dts | 2 ++
> 1 file changed, 2 insertions(+)
>
> Index: renesas/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> ===================================================================
> --- renesas.orig/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> +++ renesas/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> @@ -44,6 +44,8 @@
> phy0: ethernet-phy@0 {
> rxc-skew-ps = <1500>;
> reg = <0>;
> + interrupt-parent = <&gpio1>;
> + interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
Could you consider following-up with a patch to add:
reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
> };
> };
>
>
