Hi Sergei,
Thank you for the patch.
On Friday, 12 January 2018 22:12:05 EET Sergei Shtylyov wrote:
> According to the latest revision 2.00 of the R-Car gen2 manual, the LVDS
> must be enabled and the bias crcuit enabled after the LVDS I/O pins are
> enabled, not before -- fix the gen2 LVDS startup sequence accordingly.
>
> Fixes: 90374b5c25c9 ("drm/rcar-du: Add internal LVDS encoder support")
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov@xxxxxxxxxxxxxxxxxx>
>
> ---
> drivers/gpu/drm/rcar-du/rcar_du_lvdsenc.c | 11 ++++++-----
> 1 file changed, 6 insertions(+), 5 deletions(-)
>
> Index: linux/drivers/gpu/drm/rcar-du/rcar_du_lvdsenc.c
> ===================================================================
> --- linux.orig/drivers/gpu/drm/rcar-du/rcar_du_lvdsenc.c
> +++ linux/drivers/gpu/drm/rcar-du/rcar_du_lvdsenc.c
> @@ -59,11 +59,8 @@ static void rcar_du_lvdsenc_start_gen2(s
>
> rcar_lvds_write(lvds, LVDPLLCR, pllcr);
>
> - /*
> - * Set the LVDS mode, select the input, enable LVDS operation,
> - * and turn bias circuitry on.
> - */
> - lvdcr0 = (lvds->mode << LVDCR0_LVMD_SHIFT) | LVDCR0_BEN | LVDCR0_LVEN;
> + /* Select the input and set the LVDS mode. */
> + lvdcr0 = lvds->mode << LVDCR0_LVMD_SHIFT;
> if (rcrtc->index == 2)
> lvdcr0 |= LVDCR0_DUSEL;
> rcar_lvds_write(lvds, LVDCR0, lvdcr0);
> @@ -73,6 +70,10 @@ static void rcar_du_lvdsenc_start_gen2(s
> LVDCR1_CHSTBY(3) | LVDCR1_CHSTBY(2) |
> LVDCR1_CHSTBY(1) | LVDCR1_CHSTBY(0) | LVDCR1_CLKSTBY);
>
> + /* Enable LVDS operation and turn bias circuitry on. */
> + lvdcr0 |= LVDCR0_BEN | LVDCR0_LVEN;
> + rcar_lvds_write(lvds, LVDCR0, lvdcr0);
This change looks good, but for the reasons explained in my replies to patch
1/2, I would set the mode here along with the BEN and LVEN bits.
> /*
> * Turn the PLL on, wait for the startup delay, and turn the output
> * on.
--
Regards,
Laurent Pinchart
