From: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> Describe the GPIO used to reset the Ethernet PHY for EthernetAVB. This allows the driver to reset the PHY during probe and after system resume. On ULCB, the enable pin of the regulator providing PHY power is always pulled high, but the driver may still need to reset the PHY if this wasn't done by the bootloader before. Inspired by patches in the BSP for the individual Salvator-X/XS boards by Kazuya Mizuguchi. Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> Signed-off-by: Simon Horman <horms+renesas@xxxxxxxxxxxx> --- arch/arm64/boot/dts/renesas/ulcb.dtsi | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm64/boot/dts/renesas/ulcb.dtsi b/arch/arm64/boot/dts/renesas/ulcb.dtsi index 0d85b315ce71..be91016e0b48 100644 --- a/arch/arm64/boot/dts/renesas/ulcb.dtsi +++ b/arch/arm64/boot/dts/renesas/ulcb.dtsi @@ -154,6 +154,7 @@ reg = <0>; interrupt-parent = <&gpio2>; interrupts = <11 IRQ_TYPE_LEVEL_LOW>; + reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>; }; }; -- 2.11.0
