Hello!
On 12/05/2017 12:29 PM, Thomas Petazzoni wrote:
Not all variants of the sh_eth hardware have Gigabit
support. Unfortunately, the current driver doesn't tell the PHY about
the limited MAC capabilities. Due to this, if you have a Gigabit
capable PHY, the PHY will advertise its Gigabit capability and
establish a link at 1Gbit/s, even though the MAC doesn't support it.
In order to avoid this, we use the recently introduced
phy_set_max_speed() to tell the PHY to not advertise speed higher than
100 MBit/s.
Tested on a SH7786 platform, with a Gigabit PHY.
Signed-off-by: Thomas Petazzoni <thomas.petazzoni@xxxxxxxxxxxxxxxxxx>
---
Changes since v1:
- Use phy_set_max_speed(), as suggested by Sergei Shtylyov
<sergei.shtylyov@xxxxxxxxxxxxxxxxxx>.
---
drivers/net/ethernet/renesas/sh_eth.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index db72d13cebb9..44ff2835c954 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
[...]
@@ -1892,9 +1893,22 @@ static int sh_eth_phy_init(struct net_device *ndev)
return PTR_ERR(phydev);
}
+ /* mask with MAC supported features */
+ if (mdp->cd->register_type != SH_ETH_REG_GIGABIT) {
+ err = phy_set_max_speed(phydev, SPEED_100);
+ if (err) {
+ netdev_err(ndev, "failed to limit PHY to 100 Mbit/s\n");
+ goto err_phy_disconnect;
Er, why do we need a *goto* here at all? Just call phy_disconnect() here
and be done with that...
+ }
+ }
+
phy_attached_info(phydev);
return 0;
+
+err_phy_disconnect:
+ phy_disconnect(phydev);
+ return err;
}
/* PHY control start function */
MBR, Sergei
