There are a few udelay() left which are in a range that they should be
usleep_range() these days.
Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>
---
Works fine for me on Lager (R-Car H2) and Salvator-X (R-Car M3-W).
Testing on other platforms very welcome even though this should be
independent of the IP core.
drivers/mmc/host/tmio_mmc_core.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/mmc/host/tmio_mmc_core.c b/drivers/mmc/host/tmio_mmc_core.c
index 583bf3262df5d4..d6ca57be16c2fd 100644
--- a/drivers/mmc/host/tmio_mmc_core.c
+++ b/drivers/mmc/host/tmio_mmc_core.c
@@ -806,7 +806,7 @@ static int tmio_mmc_execute_tuning(struct mmc_host *mmc, u32 opcode)
if (ret == 0)
set_bit(i, host->taps);
- mdelay(1);
+ usleep_range(1000, 1200);
}
ret = host->select_tuning(host);
@@ -958,7 +958,7 @@ static void tmio_mmc_power_on(struct tmio_mmc_host *host, unsigned short vdd)
* 100us were not enough. Is this the same 140us delay, as in
* tmio_mmc_set_ios()?
*/
- udelay(200);
+ usleep_range(200, 300);
}
/*
* It seems, VccQ should be switched on after Vcc, this is also what the
@@ -966,7 +966,7 @@ static void tmio_mmc_power_on(struct tmio_mmc_host *host, unsigned short vdd)
*/
if (!IS_ERR(mmc->supply.vqmmc) && !ret) {
ret = regulator_enable(mmc->supply.vqmmc);
- udelay(200);
+ usleep_range(200, 300);
}
if (ret < 0)
@@ -1059,7 +1059,7 @@ static void tmio_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
}
/* Let things settle. delay taken from winCE driver */
- udelay(140);
+ usleep_range(140, 200);
if (PTR_ERR(host->mrq) == -EINTR)
dev_dbg(&host->pdev->dev,
"%s.%d: IOS interrupted: clk %u, mode %u",
--
2.11.0
