Hi Biju-san,
IIUC, when we submitted a patch for dts[i] file,
we don't need to submit such a patch to usb maintainers.
> From: Biju Das, Sent: Monday, October 16, 2017 7:13 PM
>
> From: Fabrizio Castro <fabrizio.castro@xxxxxxxxxxxxxx>
>
> Add node for xhci. Boards DT files will enable it if needed.
>
> Signed-off-by: Fabrizio Castro <fabrizio.castro@xxxxxxxxxxxxxx>
> ---
> arch/arm/boot/dts/r8a7743.dtsi | 20 ++++++++++++++++++++
> 1 file changed, 20 insertions(+)
>
> diff --git a/arch/arm/boot/dts/r8a7743.dtsi b/arch/arm/boot/dts/r8a7743.dtsi
> index 699c040..386bf07 100644
> --- a/arch/arm/boot/dts/r8a7743.dtsi
> +++ b/arch/arm/boot/dts/r8a7743.dtsi
> @@ -931,6 +931,26 @@
> status = "disabled";
> };
>
> + /*
> + * pci1 and xhci share the same phy, therefore only one of them
> + * can be active at any one time. If both of them are enabled,
> + * a race condition will determine who'll control the phy.
> + * A firmware file is needed by the xhci driver in order for
> + * USB 3.0 to work properly.
> + */
> + xhci: usb@ee000000 {
> + compatible = "renesas,xhci-r8a7743",
> + "renesas,rcar-gen2-xhci";
> + reg = <0 0xee000000 0 0xc00>;
> + interrupts = <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&cpg CPG_MOD 328>;
> + power-domains = <&sysc R8A7743_PD_ALWAYS_ON>;
> + resets = <&cpg 328>;
> + phys = <&usb2 1>;
> + phy-names = "usb";
> + status = "disabled";
> + };
> +
> sdhi0: sd@ee100000 {
> compatible = "renesas,sdhi-r8a7743";
> reg = <0 0xee100000 0 0x328>;
It seems good to me. So,
Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
Best regards,
Yoshihiro Shimoda
> --
> 1.9.1
