Hello Sergei, Thank you for your comments. > From: Sergei Shtylyov [mailto:sergei.shtylyov@xxxxxxxxxxxxxxxxxx] > Sent: 05 July 2017 17:14 > > Hello! > > On 07/05/2017 06:56 PM, Biju Das wrote: > > > The iWave RZ/G1M Q7 SOM supports Gigabit Ethernet Phy (Micrel > KSZ9031MNX). > > Gigabit Ethernet support is available in Renesas AVB driver. > > To increase hardware support enable the driver in the > > shmobile_defconfig multiplatform configuration. > > > > Signed-off-by: Biju Das <biju.das@xxxxxxxxxxxxxx> > > Reviewed-by: Chris Paterson <chris.paterson2@xxxxxxxxxxx> > > Acked-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > > --- > > arch/arm/configs/shmobile_defconfig | 1 + > > 1 file changed, 1 insertion(+) > > > > diff --git a/arch/arm/configs/shmobile_defconfig > > b/arch/arm/configs/shmobile_defconfig > > index 3c66a42..d992911 100644 > > --- a/arch/arm/configs/shmobile_defconfig > > +++ b/arch/arm/configs/shmobile_defconfig > > @@ -83,6 +83,7 @@ CONFIG_NETDEVICES=y > > # CONFIG_NET_VENDOR_MICREL is not set # > CONFIG_NET_VENDOR_NATSEMI is > > not set CONFIG_SH_ETH=y > > +CONFIG_RAVB=y > > Hm, I would enable it only as a module, given it's not easy to make use of > AVB on the 32-bit boards. On the iWave-M platforms the only available Ethernet interface is AVB. Without including the RAVB driver in the Kernel we won't be able to use NFS. I know adding CONFIG_RAVB for all shmobile devices may increase the Kernel size for everyone, especially when most cannot use AVB without an add-on board, but I don't think the increase will be big. Kind regards, Chris > > [...] > > MBR Sergei
